RTMNU · Third Year B.Tech Mechanical Engineering · NEP 2020
Mechanical Measurement and Metrology
BME6T18 · Semester VI · 2 credits · College 30 + university 70
Unit 1: Static and Dynamic Characteristics
7 hoursPurpose, structure and elements of a measuring system, static characteristics, calibration and error analysis; performance characteristics, standard test inputs, the order of a system and the time and frequency response of first- and second-order systems.
Examined in the 70-mark end-semester paper
- Elements of measuring instruments
- Static and dynamic characteristics
- Calibration
- Errors in measurement
- Standard test signals
- First-order system response
- Second-order system response and time-domain specifications
Unit 2: Study of Instruments
7 hoursConstruction, range and working of instruments for linear and angular displacement, speed, load, strain, force, torque, power, pressure, vacuum and temperature.
Examined in the 70-mark end-semester paper
- Displacement, position and proximity sensors
- Electrical resistance strain gauges and gauge factor
- Wheatstone bridge configurations for strain gauges
- Speed and load measurement: tachometers and load cells
- Dynamometers: absorption and transmission
- Pressure gauges
- Vacuum measurement
- Thermocouples and RTDs
Unit 3: Standards; Limits, Fits and Tolerances
7 hoursLine, end, wavelength and working standards, interchangeability and selective assembly; limits and fits, the shaft and hole basis systems, types of limit gauges and their design.
Examined in the 70-mark end-semester paper
- Measurement standards, errors and uncertainty
- Interchangeability and selective assembly
- Limits, fits and tolerances
- Gauge design and Taylor's principle
Unit 4: Linear and Angular Metrology
7 hoursVernier, micrometer, bevel protractor, angle gauges, sine bar and slip gauges, spirit level, clinometer and taper gauges, the optical flat for flatness; mechanical, optical, electrical, electronic and pneumatic comparators; the profile projector, toolmaker's microscope and autocollimator.
Examined in the 70-mark end-semester paper
- Linear measuring instruments and gauges
- Angular measurement: sine bar and bevel protractor
- Interferometry and flatness testing
- Comparators
- Optical and non-contact metrology
Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).