RTMNU Final Mechanical syllabus

RTMNU · Final Year B.Tech Mechanical Engineering · CBCS

Design of Transmission Systems

BEME704T · Semester VII · 4 credits · College 30 + university 70

3 lectures and 1 tutorial a week, 4 credits.

  1. Unit 1: Rolling and Sliding Contact Bearings

    8 hours

    Types of rolling bearings, static and dynamic capacities, Stribeck's equation, equivalent load, load–life relation and catalogue selection, bearings for cyclic loads and speeds and for reliabilities other than 90%; sliding bearings, hydrodynamic lubrication, the Reynolds equation, Sommerfeld number, Raimondi and Boyd method, thermal considerations and journal and thrust bearing design.

    Examined in the 70-mark end-semester paper

    • Types of rolling contact bearings
    • Static and dynamic load capacity
    • Equivalent load and bearing life
    • Selecting bearings from a catalogue
    • Bearing life for cyclic loads and reliability other than 90%
    • Hydrodynamic sliding bearings
    • Reynolds' equation
    • Raimondi and Boyd charts and the Sommerfeld number
  2. Unit 2: Belt and Wire Rope Drives

    7 hours

    Flat belts — belt tension, condition for maximum power, belt and pulley design; V-belts and pulleys; an introduction to synchronous (toothed) belts; wire ropes — stresses in hoisting ropes, rope, sheave and drum design.

    Examined in the 70-mark end-semester paper

    • Design of flat belt drives
    • Condition for maximum power transmission
    • Selecting V-belts from catalogues
    • Synchronous (toothed) belt drives
    • Design of wire ropes
  3. Unit 3: Spur and Helical Gears

    7 hours

    Gear and material selection, tooth failure, lubrication, teeth and face width, force analysis, Lewis beam strength, velocity, service and load-concentration factors, Buckingham wear strength, module from beam and wear strength, dynamic load; helical gear terminology, virtual teeth, forces and drive design.

    Examined in the 70-mark end-semester paper

    • Gear materials and modes of tooth failure
    • Spur gear force analysis
    • Beam strength: the Lewis equation
    • Wear strength and dynamic load: Buckingham's equation
    • Design of spur gears
    • Design of helical gears
  4. Unit 4: Worm and Bevel Gears

    7 hours

    Worm gearing and the AGMA equation, worm-gear forces, designing a worm-gear mesh and Buckingham wear load; bevel gear types, proportions, force analysis and design of straight bevel gear drives.

    Examined in the 70-mark end-semester paper

    • Worm gear terminology and force analysis
    • Worm gear efficiency and thermal rating
    • Straight bevel gears
  5. Unit 5: Flywheels and Chain Drives

    7 hours

    Flywheel functions, coefficients of fluctuation of energy and speed, energy storage, stresses and flywheel design; roller chain drives — velocity ratio, chain length, chain and sprocket design.

    Examined in the 70-mark end-semester paper

    • Turning moment diagrams and flywheels
    • Design of flywheels: rim stresses and dimensions
    • Design of chain drives

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).