PAHSU TY Mechanical syllabus

PAHSU · Third Year B.Tech. Mechanical Engineering · NEP 2020

Metrology and Quality Control

MECHPEC-01A · Programme Elective I · Semester V · 4 credits · ISE 30 + ESE 70

One of the Programme Elective I options.

  1. Unit 1: Fundamentals of Metrology

    6 hours

    Scope of metrology in manufacturing; line, end, wavelength and atomic standards; systematic, random and environmental errors; calibration and traceability; precision, accuracy and sensitivity of instruments.

    Examined in the 70-mark end-semester paper

    • Measurement standards, errors and uncertainty
    • Accuracy, precision and gauge R&R
  2. Unit 2: Linear, Angular and Surface Metrology

    8 hours

    Vernier callipers, micrometers, slip gauges and dial indicators; sine bar, bevel protractor and angle gauges; surface roughness parameters and profilometers; mechanical, optical, pneumatic and electrical comparators.

    Examined in the 70-mark end-semester paper

    • Linear measuring instruments and gauges
    • Angular measurement: sine bar and bevel protractor
    • Surface texture measurement
    • Comparators
  3. Unit 3: Gear and Thread Measurement

    6 hours

    Gear tooth thickness, pitch, addendum and dedendum; profile and run-out measurement, the rolling test and composite error; major, minor and effective diameters of threads.

    Examined in the 70-mark end-semester paper

    • Gear metrology
    • Screw thread metrology
  4. Unit 4: Introduction to Quality Control

    6 hours

    Quality control and assurance, cost of quality; 100% versus sampling inspection; six sigma, DMAIC and lean principles.

    Examined in the 70-mark end-semester paper

    • Quality concepts and cost of quality
    • Six sigma and DMAIC
    • Lean principles and lean six sigma
  5. Unit 5: Statistical Quality Control and Process Capability

    8 hours

    The normal distribution and process variability; X-bar and R, p and c charts; Cp, Cpk, Pp and Ppk; single and double sampling plans.

    Examined in the 70-mark end-semester paper

    • Variation and statistical process control
    • Control charts for variables
    • Control charts for attributes
    • Process capability indices
    • Acceptance sampling and OC curves
    • Sampling plans: single, double, multiple and sequential
  6. Unit 6: Quality Management Systems and Tools

    6 hours

    ISO 9000, ISO 14000 and TQM; FMEA and the PDCA cycle; the seven QC tools: Pareto chart, cause-and-effect diagram, histogram and control charts.

    Examined in the 70-mark end-semester paper

    • ISO 9000 and ISO 14000
    • Quality management systems and awards
    • FMEA and FMECA
    • Seven quality tools

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).