GUG TY Mechanical syllabus

GUG · Third Year B.Tech. Mechanical Engineering · NEP 2020

Dynamics of Machines

STPCCMEC604 · Semester VI · 3 credits · IE 10 + mid-semester 10 + ESE 80

No numericals on governors.

  1. Unit 1: Static and Dynamic Force Analysis

    9 hours

    Constraint and applied forces, static equilibrium of two- and three-force members and of members with forces and torque, free-body diagrams, superposition, virtual work and friction in mechanisms; D'Alembert's principle and the equivalent offset inertia force; dynamic analysis of slider-crank and four-link mechanisms, piston velocity and acceleration, engine force analysis and crankshaft torque; dynamically equivalent systems and the inertia of the connecting rod.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Static force analysis of mechanisms
    • Virtual work and D'Alembert's principle
    • Dynamic force analysis of four-bar and slider-crank mechanisms
    • Dynamically equivalent systems and inertia of the connecting rod
  2. Unit 2: Flywheels, Gyroscopes and Governors

    9 hours

    Turning moment diagrams for single-cylinder four-stroke and multi-cylinder engines, fluctuation of energy and flywheel rims; gyroscopic couple and its effect on aeroplanes, ships and two-wheelers; Watt, Porter, Proell, Hartnell, centrifugal and inertia governors, hunting and isochronism (no numericals on governors).

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Turning moment diagrams and flywheels
    • Gyroscopic couple
    • Gyroscopic effect on aeroplanes and ships
    • Stability of four-wheel and two-wheel vehicles
    • Porter and Hartnell governors
    • Governor characteristics: sensitiveness, hunting and isochronism
  3. Unit 3: Longitudinal and Transverse Vibrations

    9 hours

    Free, damped and forced longitudinal vibrations, logarithmic decrement, magnification factor, isolation and transmissibility; natural transverse vibrations of shafts and beams under point and distributed loads, Dunkerley's and energy methods; critical or whirling speed.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Undamped free vibration
    • Damped free vibration and logarithmic decrement
    • Forced vibration and frequency response
    • Transmissibility and vibration isolation
    • Free longitudinal and transverse vibrations
    • Critical speed of shafts
  4. Unit 4: Torsional Vibrations

    9 hours

    Free torsional vibrations of single-, two- and three-rotor systems; torsionally equivalent shafts; free torsional vibrations of geared systems.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Torsional vibration of single and two-rotor systems
    • Torsional vibration of geared systems
  5. Unit 5: Balancing

    9 hours

    Static and dynamic balancing; balancing several rotating masses in different planes; balancing reciprocating masses, hammer blow, variation of tractive force and swaying couple; secondary balancing; balancing locomotives, in-line and radial engines.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Static and dynamic balancing
    • Balancing rotating masses in several planes
    • Balancing of reciprocating masses
    • Primary and secondary balancing
    • Partial balancing of locomotives
    • Balancing of multi-cylinder, V and radial engines

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.