SPPU TE Electrical syllabus

SPPU · Third Year Electrical Engineering · 2024 Pattern

Computer Aided Design of Electrical Machines

PEC-321C-ELE · Elective I · Semester V · 3 credits · CCE 30 + end-semester 70

One of the Elective I options.

  1. Unit 1: Transformer Design (Part I)

    8 hours

    Core and winding construction; heating and cooling time constants; IS 2026 specifications; the output equation; designing for minimum cost and loss; core design and overall frame dimensions.

    Marks: 14 in the end-semester exam · CCE: Unit test (12 marks, Units 1 & 2)

    • Transformer construction and specifications
    • Heating and cooling of transformers
    • Output equation of a transformer
    • Design of the core and frame
  2. Unit 2: Transformer Design (Part II)

    8 hours

    Winding design; resistance and leakage reactance; no-load current, losses, efficiency and regulation; short-circuit forces; cooling methods and tank design; computer-aided design flow charts.

    Marks: 14 in the end-semester exam · CCE: Unit test (12 marks, Units 1 & 2)

    • Design of transformer windings
    • Leakage reactance of transformers
    • Short-circuit forces
    • Cooling and tank design
    • Computer-aided transformer design
  3. Unit 3: Induction Motor Design (Part I)

    8 hours

    Specifications and construction; AC windings; specific electric and magnetic loadings; the output equation; main dimensions, turns and stator slots; stator–rotor slot combinations; the air gap; design flow chart.

    Marks: 14 in the end-semester exam · CCE: Assignments or case study (12 marks, Units 3 & 4)

    • Specific electric and magnetic loadings
    • Output equation of an induction motor
    • Main dimensions and stator design
    • Air gap length
  4. Unit 4: Induction Motor Design (Part II)

    8 hours

    Cage rotor bars and end rings; wound rotor slots; slot, tooth-top, zig-zag and overhang leakage; MMF of the air gap, teeth and cores; saturation and ducts; no-load current; losses and efficiency.

    Marks: 14 in the end-semester exam · CCE: Assignments or case study (12 marks, Units 3 & 4)

    • Cage rotor design
    • Wound rotor design
    • Leakage reactance of induction motors
    • Magnetising current calculation
  5. Unit 5: Special Machine Design

    8 hours

    Brushless motor torque, back EMF and magnetic circuit; inner- and outer-rotor radial-flux machines; PMSM design examples; SRM sizing and stator and rotor design.

    Marks: 14 in the end-semester exam · CCE: Seminar, open-book test or quiz (6 marks, Unit 5)

    • Brushless motor fundamentals
    • PMSM design
    • Switched reluctance motor design

Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.