SPPU TE Civil syllabus

SPPU · Third Year Civil Engineering · 2024 Pattern

Design of Steel Structures

PCC-301-CVL · Semester V · 3 credits · CCE 30 + end-semester 70

  1. Unit 1: Design Philosophy and Tension Members

    9 hours

    Steel properties, grades and rolled sections; IS 800, 875 and 808; limit state design, load combinations and safety factors; pre-engineered buildings and cold-formed sections; sustainability; tension members (rods, cables, angles), yielding, rupture and block shear, single- and double-angle truss members and their connections.

    Marks: 14 in the end-semester exam · CCE: Unit test (12 marks, Units 1 & 2)

    • Steel structures, sections and IS codes
    • Limit state design and load combinations
    • Pre-engineered buildings and cold-formed sections
    • Tension members: yielding, rupture and block shear
    • Design of tension members and connections
  2. Unit 2: Compression Members and Columns

    9 hours

    Buckling classes and curves, section classification, effective length, design compressive stress; angle struts and connections; axially loaded rolled-section and built-up columns; lacing and battening.

    Marks: 14 in the end-semester exam · CCE: Unit test (12 marks, Units 1 & 2)

    • Buckling and design compressive stress
    • Design of angle struts
    • Design of axially loaded columns
    • Built-up columns: lacing and battening
  3. Unit 3: Flexural Members

    9 hours

    Design bending strength; laterally restrained beams with and without flange plates, curtailment, low and high shear, web buckling, crippling and deflection; laterally unrestrained beams; purlins.

    Marks: 14 in the end-semester exam · CCE: Assignments or case study (12 marks, Units 3 & 4)

    • Design bending strength of beams
    • Laterally restrained beams
    • Web buckling, web crippling and deflection
    • Laterally unrestrained beams
    • Design of purlins
  4. Unit 4: Eccentrically Loaded Columns and Column Bases

    9 hours

    Columns under uniaxial and biaxial bending, section and member strength; slab, gusseted and moment-resisting bases.

    Marks: 14 in the end-semester exam · CCE: Assignments or case study (12 marks, Units 3 & 4)

    • Columns under axial load and bending
    • Slab base
    • Gusseted base
    • Moment-resisting column base
  5. Unit 5: Plate Girders and Gantry Girders

    9 hours

    Welded plate girders: section design, flange curtailment, bearing and intermediate stiffeners, flange–web and web–stiffener welds, shear buckling and end panels; gantry girders: section, moment capacity, buckling, biaxial bending, serviceability and fatigue.

    Marks: 14 in the end-semester exam · CCE: Seminar, open-book test or quiz (6 marks, Unit 5)

    • Welded plate girder: section design
    • Plate girder stiffeners and connections
    • Shear buckling of the web
    • Gantry girder design

Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.