SPPU · Final Year Mechanical Engineering · 2019 Course
Process Equipment Design
402051A · Elective VI · Semester VIII · 3 credits · In-semester 30 + end-semester 70
One of the Elective VI options.
Unit 1: Process Design
Process block diagrams and material balance; design pressure, temperature and stress; factor of safety, minimum thickness and corrosion allowance; weld joint efficiency; stress concentration and thermal stress; Lagrange multipliers and golden-section optimisation; cost estimation; design codes.
Marks: 15 in the in-semester exam
- Process design basics
- Design pressure, stress and corrosion allowance
- Optimisation in process design
Unit 2: Piping Design
Thin and thick cylinders and prestressing; piping codes; flow diagrams and symbols; layouts for water, steam and compressed air; couplings.
Marks: 15 in the in-semester exam
- Thin and thick cylinders
- Piping codes and layouts
Unit 3: Pressure Vessels
Classes of vessels; end closures; discontinuity stresses; opening compensation; standard and non-standard flanges; external pressure; supports; tall vessels under wind and seismic loads.
Marks: 17–18 in the end-semester exam
- Design of cylindrical and spherical vessels
- End closures and opening compensation
- Flange design
- Tall vessels under wind and seismic loads
Unit 4: Process Equipment
Storage and reaction vessels; agitators and mixers; heat exchangers, filters, driers and centrifuges; selecting pumps, compressors and auxiliaries; valves, fittings, linings, expansion joints and pipe supports.
Marks: 17–18 in the end-semester exam
- Storage and reaction vessels
- Agitators and mixers
- Valves, expansion joints and pipe supports
Unit 5: Process Control
Process parameters and their relations; process measurement and control; control of major unit operations.
Marks: 17–18 in the end-semester exam
- Process parameters and their correlations
- Process measurement and control
Unit 6: Execution and Applications
Planning, manufacture, inspection and erection of vessels, chimneys, ducts and heat exchangers; coatings and linings; fuel pumping stations, fire extinguishers, HVAC and fume extraction.
Marks: 17–18 in the end-semester exam
- Fabrication and inspection of process equipment
- Applications of process equipment design
Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.