SGBAU · Second Year B.E. Mechanical Engineering · NEP 2020
Fluid Mechanics
4ME210PC · Semester IV · 3 credits · IE 40 + ESE 60
Unit 1: Fluid Properties and Pressure
Density, specific weight, specific volume and gravity, viscosity, surface tension, capillarity, vapour pressure and cavitation; Pascal's law, the hydrostatic law and manometers.
Examined in the 60-mark end-semester paper
- Properties of fluids
- Viscosity and types of fluids
- Surface tension and capillarity
- Pascal's law and the hydrostatic law
- Pressure measurement and manometers
Unit 2: Buoyancy and Hydrostatic Forces
Buoyancy and the centre of buoyancy, stability of floating and submerged bodies and the metacentric height; hydrostatic force and the centre of pressure on plane and curved surfaces.
Examined in the 60-mark end-semester paper
- Buoyancy and stability of floating bodies
- Forces on submerged plane and curved surfaces
Unit 3: Fluid Kinematics and Dynamics
Describing fluid motion, types of flow, streamlines, potential lines and flow nets, velocity and acceleration, the three-dimensional continuity equation; Euler's and Bernoulli's equations and the venturimeter.
Examined in the 60-mark end-semester paper
- Types of flow and flow description
- Stream function, velocity potential and flow nets
- Continuity equation
- Euler's equation and Bernoulli's theorem
- Venturimeter, orifice meter and pitot tube
Unit 4: Flow Through Pipes
Major losses and the Darcy–Weisbach equation, minor losses at enlargements, contractions, entry, exit and fittings, pipes in series and parallel, and water hammer.
Examined in the 60-mark end-semester paper
- Major and minor losses and the Moody chart
- Pipes in series and parallel and equivalent pipe
- Water hammer
Unit 5: Viscous Flow and Boundary Layers
Laminar and turbulent flow, the Reynolds number, the boundary layer and its separation, and drag and lift on bodies.
Examined in the 60-mark end-semester paper
- Laminar flow through pipes
- Dimensionless numbers
- Boundary layer on a flat plate
- Boundary layer separation and its control
- Drag and lift
Unit 6: Principles of Fluid Machinery
Force exerted by a jet on stationary and moving flat and curved vanes, velocity diagrams, work done and efficiency, and volumetric, hydraulic, mechanical and overall efficiencies.
Examined in the 60-mark end-semester paper
- Impact of jets on plates and vanes
- Velocity triangles and work done
- Heads and efficiencies of pumps
Unit contents are summarised from the official SGBAU syllabus . AiCanCode.org is not affiliated with Sant Gadge Baba Amravati University (SGBAU).