RTMNU SY Civil syllabus

RTMNU · Second Year B.Tech Civil Engineering · NEP 2020

Concrete Technology

BCV3T10 · Semester III · 3 credits · College 30 + university 70

  1. Unit 1: Cement and Aggregate

    8 hours

    Constituents and hydration of cement, its physical tests (fineness, setting times, soundness, strength) and grades and types; coarse and fine, light and heavy aggregates, their shape, grading, strength and tests, bulking of sand, crushed sand, alkali–aggregate reaction and water for mixing.

    Examined in the 70-mark end-semester paper

    • Cement: manufacture, types and hydration
    • Tests on cement: fineness, setting time and soundness
    • Aggregates and their properties
    • Aggregate tests: crushing, impact and abrasion values
    • Bulking of sand and crushed sand
    • Durability: sulphate attack and alkali–silica reaction
    • Quality of water for concrete
  2. Unit 2: Fresh Concrete

    7 hours

    Batching and mixing plants, workability and its measurement, the water–cement ratio, segregation, bleeding and permeability; conveying, placing, compaction and curing, maturity, formwork, hot and cold weather concreting, and ready-mix, pumped and self-compacting concrete.

    Examined in the 70-mark end-semester paper

    • Batching, mixing, placing and curing
    • Workability and its tests
    • Segregation and bleeding
    • Maturity of concrete
    • Formwork and scaffolding
    • Hot-weather, cold-weather and mass concreting
    • Ready-mixed concrete
    • High-performance and self-compacting concrete
  3. Unit 3: Strength of Concrete

    7 hours

    Strength gain, compressive, tensile and flexural strengths and their relations, failure modes, impact and fatigue strength, elasticity and Poisson's ratio; cube and cylinder tests, split tension and accelerated curing, and non-destructive testing by rebound hammer and ultrasonic pulse velocity.

    Examined in the 70-mark end-semester paper

    • Strength of hardened concrete
    • Cube, cylinder and split tensile strength tests
    • Strength and elastic properties of hardened concrete
    • Non-destructive testing of concrete
  4. Unit 4: Mix Design

    7 hours

    Objectives and process of mix design, the statistical relation between mean and characteristic strength, factors affecting mix proportions, degree of quality control, the IS method, and an introduction to the Road Note No. 4 (BS) and ACI methods.

    Examined in the 70-mark end-semester paper

    • Principles of mix design
    • Quality control and acceptance criteria
    • IS 10262 mix design method
    • ACI and DoE methods of mix design
  5. Unit 5: Additives and Admixtures

    7 hours

    Natural and by-product pozzolanas (fly ash, silica fume, rice husk ash, metakaolin, GGBS) and chemical admixtures (air entraining, water reducing, accelerators, retarders, superplasticisers); early volume changes, drying shrinkage, carbonation and creep.

    Examined in the 70-mark end-semester paper

    • Mineral admixtures: fly ash, silica fume and GGBS
    • Chemical admixtures and rheology
    • Admixtures and fibres
    • Creep and shrinkage of concrete
    • Carbonation and chloride ingress

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).