PAHSU TY Mechanical syllabus

PAHSU · Third Year B.Tech. Mechanical Engineering · NEP 2020

Transmission System Design

MECHPCC-10 · Semester VI · 3 credits · ISE 30 + ESE 70

  1. Unit 1: Spur Gears

    6 hours

    Gear design considerations and materials; tooth failures and the hunting tooth; tooth loads, minimum number of teeth and face width; the Lewis equation, Spotts' equation and Buckingham's equation; design for maximum power; the AGMA code.

    Examined in the 70-mark end-semester paper

    • Gear materials and modes of tooth failure
    • Spur gear force analysis
    • Beam strength: the Lewis equation
    • Wear strength and dynamic load: Buckingham's equation
    • Design of spur gears
  2. Unit 2: Helical Gears

    4 hours

    Virtual number of teeth; helical gears designed on beam strength and wear; the effective tooth load.

    Examined in the 70-mark end-semester paper

    • Design of helical gears
  3. Unit 3: Worm Gears

    5 hours

    Worm gear terminology, materials and standard proportions; friction and efficiency; design to IS 7443-1974; load, strength and wear ratings; thermal considerations.

    Examined in the 70-mark end-semester paper

    • Worm gear terminology and force analysis
    • Worm gear efficiency and thermal rating
  4. Unit 4: Bevel Gears

    5 hours

    Bevel gear terminology and geometry, virtual number of teeth; design on beam and wear strength; dynamic and effective tooth load.

    Examined in the 70-mark end-semester paper

    • Straight bevel gears
  5. Unit 5: Rolling and Sliding Contact Bearings

    7 hours

    Types of rolling bearings, static and dynamic capacity, equivalent load and the load-life relation; selection from catalogues; variable load and speed; reliability other than 90%; sliding-bearing materials and types; hydrodynamic and hydrostatic bearings.

    Examined in the 70-mark end-semester paper

    • Types of rolling contact bearings
    • Static and dynamic load capacity
    • Equivalent load and bearing life
    • Selecting bearings from a catalogue
    • Bearing life for cyclic loads and reliability other than 90%
    • Hydrodynamic sliding bearings
  6. Unit 6: Friction Clutches and Brakes

    4 hours

    Single- and multi-plate, cone and centrifugal clutches, energy and thermal considerations; band, block, external-shoe, internal-expanding-shoe and disc brakes.

    Examined in the 70-mark end-semester paper

    • Friction clutches
    • Cone and centrifugal clutches
    • Band and shoe brakes
    • Disc brakes

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).