PAHSU TY Civil syllabus

PAHSU · Third Year B.Tech. Civil Engineering · NEP 2020

Design of Steel Structures

CIVPCC-07 · Semester V · 3 credits · ISE 30 + ESE 70

IS 800-2007, steel tables and SP 6(1) are allowed in the theory exam.

  1. Unit 1: Introduction to Steel Design and Plastic Analysis

    8 hours

    Steel as a structural material, limit state design for strength and serviceability, rolled sections and IS recommendations; pre-engineered buildings, their materials and advantages over conventional steel buildings; plastic moment, moment-curvature relation, plastic hinges, shape factor, mechanisms, theorems of plastic analysis and collapse loads of beams by virtual work; plastic, compact, semi-compact and slender sections.

    Examined in the 70-mark end-semester paper

    • Steel structures, sections and IS codes
    • Limit state design and load combinations
    • Pre-engineered buildings and cold-formed sections
    • Plastic analysis: hinges and collapse mechanisms
    • Classification of cross-sections
  2. Unit 2: Design of Connections

    7 hours

    Types of bolts and bolted joints, failure and efficiency of bolted connections; types of welded joints, design strength of fillet and butt welds.

    Examined in the 70-mark end-semester paper

    • Bolted and welded connections to IS 800:2007
    • Bolted and riveted connections
    • Welded connections and fillet welds
  3. Unit 3: Tension Members

    8 hours

    Threaded rods, cables and angle sections; net effective area; design strength in yielding, rupture and block shear; design of tension members, their bolted and welded connections to gusset plates, and tension splices.

    Examined in the 70-mark end-semester paper

    • Tension members: yielding, rupture and block shear
    • Design of tension members and connections
    • Shear lag and lug angles
  4. Unit 4: Compression Members: Struts and Columns

    9 hours

    Sections for compression members, buckling classes and curves, effective length and slenderness ratio; design of struts and their connections; simple and built-up columns, lacing and battening and their connections; columns under axial force and bending.

    Examined in the 70-mark end-semester paper

    • Buckling and design compressive stress
    • Design of angle struts
    • Design of axially loaded columns
    • Built-up columns: lacing and battening
    • Columns under axial load and bending
  5. Unit 5: Beams

    7 hours

    Laterally supported and unsupported beams under low and high shear; secondary and main beam floor framing; bolted and welded beam-to-beam connections.

    Examined in the 70-mark end-semester paper

    • Design bending strength of beams
    • Laterally restrained beams
    • Laterally unrestrained beams
    • Web buckling, web crippling and deflection
    • Sections under high shear
    • Beam-to-beam connections
  6. Unit 6: Column Bases

    6 hours

    Slab and gusseted bases under axial load, anchor bolts and pedestals; column bases for axial load and uniaxial bending.

    Examined in the 70-mark end-semester paper

    • Slab base
    • Gusseted base
    • Moment-resisting column base

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).