PAHSU SY Electrical syllabus

PAHSU · Second Year B.Tech. Electrical Engineering · NEP 2020

Power Plant Engineering and Elements of Power System

EEPCC-02 · Semester III · 3 credits · ISE 30 + ESE 70

Unit 6 (Substations and Grounding) is untitled in the PDF; the title here follows its contents.

  1. Unit 1: Base Load Power Plants

    7 hours

    Conventional and non-conventional energy sources and the structure of the power industry; hydro plants: layout, site selection, classification, hydrographs, flow duration curves and turbines; thermal plants: layout, site selection, fuel handling, combustion, ash handling and dust collection; nuclear plants: layout, site selection, AGR, PWR and BWR reactors, waste disposal and environmental aspects.

    Examined in the 70-mark end-semester paper

    • Conventional and non-conventional sources of power
    • Hydroelectric plant site selection and classification
    • Water turbines and governors
    • Thermal plant site selection and layout
    • Coal and ash handling systems
    • Nuclear fission and chain reaction
    • Nuclear reactors: types, control, shielding and waste disposal
  2. Unit 2: Peak Load Power Plants

    6 hours

    Diesel and gas turbine plants: advantages, layout and site selection; solar thermal and wind power plants: advantages, layout and site selection.

    Examined in the 70-mark end-semester paper

    • Diesel power plants
    • Gas turbine power plants
    • Solar photovoltaic and solar thermal generation
    • Wind generators
  3. Unit 3: Economic Aspects of Power Generation

    7 hours

    Terms used in system operation; variable load, peak and base load, diversity factor, plant use factor and maximum demand; load and load duration curves; selecting generating units and economics of plant selection; economic load sharing and interconnected grids; cost of electrical energy and types of tariff.

    Examined in the 70-mark end-semester paper

    • Load duration curve, plant factor and plant economics
    • Load curves and load factors
    • Selection of plant size and number of units
    • Parallel operation and load sharing of power plants
    • Costs and tariffs of power plants
    • Two-part and three-part tariffs
  4. Unit 4: General Electric Power Systems and Economics

    8 hours

    The electrical supply system and a typical AC supply scheme; DC versus AC transmission; advantages of high transmission voltage; overhead versus underground systems by volume of conductor material; choice of transmission voltage, conductor size and Kelvin's law.

    Examined in the 70-mark end-semester paper

    • Structure of a power system
    • Comparison of supply systems
    • Choice of transmission voltage
    • Kelvin's law
  5. Unit 5: Mechanical Design of Overhead Lines

    8 hours

    Main components of overhead lines, conductor materials and line supports; pin, suspension and strain insulators; string efficiency and methods of improving it.

    Examined in the 70-mark end-semester paper

    • Conductor materials: copper and ACSR
    • Types of overhead line insulators
    • String efficiency
  6. Unit 6: Substations and Grounding

    6 hours

    Classification of substations, equipment symbols and substation equipment; grounding of the transformer neutral: resistance, reactance and solid grounding.

    Examined in the 70-mark end-semester paper

    • Station equipment, switchyard and control room
    • Substation equipment and their ratings
    • Neutral grounding: solid, resistance and reactance

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).