PAHSU SY Electrical syllabus

PAHSU · Second Year B.Tech. Electrical Engineering · NEP 2020

Electrical Transmission and Distribution

EEPCC-04 · Semester IV · 3 credits · ISE 30 + ESE 70

  1. Unit 1: Corona and Sag in Overhead Lines

    7 hours

    Corona: principle, terms and empirical formulae, factors affecting it, advantages, disadvantages and methods of reducing it; sag in overhead lines and its calculation.

    Examined in the 70-mark end-semester paper

    • Corona and corona loss
    • Sag calculation for overhead lines
    • Effect of ice and wind loading
    • Sag with supports at unequal levels
  2. Unit 2: Constants of Transmission Lines

    7 hours

    Line resistance, skin and proximity effects; inductance of a single-phase two-wire line, GMR and GMD; inductance of three-phase lines with equilateral and unsymmetrical spacing and transposition; capacitance of single- and three-phase lines and the effect of earth.

    Examined in the 70-mark end-semester paper

    • Skin and proximity effects
    • Inductance of a single-phase line
    • GMR and GMD
    • Inductance of three-phase lines and transposition
    • Capacitance of a single-phase line
    • Capacitance of three-phase lines
    • Effect of earth on capacitance
  3. Unit 3: Underground Cables

    6 hours

    Construction, insulating materials and classification of cables; insulation resistance, capacitance and dielectric stress of a single-core cable; grading of cables; capacitance of three-phase cables.

    Examined in the 70-mark end-semester paper

    • Underground cables and dielectric stress
    • Grading of cables
    • Cables: types, jointing and insulation resistance
  4. Unit 4: Performance of Transmission Lines

    8 hours

    Classification of lines; performance of short lines and the effect of load power factor on regulation and efficiency; medium lines by the end-condenser, nominal-T and nominal-pi methods; rigorous solution of long lines; generalised ABCD constants; Ferranti effect.

    Examined in the 70-mark end-semester paper

    • Classification of transmission lines
    • Performance of short lines
    • Efficiency and regulation of lines
    • Nominal-T and nominal-pi models
    • Long transmission lines
    • ABCD constants
    • Ferranti effect
  5. Unit 5: Distribution Systems

    6 hours

    Classification and connection schemes; DC distributors fed at one and both ends with concentrated loads, and ring mains; AC distribution calculations; three-phase three-wire and four-wire loads.

    Examined in the 70-mark end-semester paper

    • Classification and requirements of distribution systems
    • DC distributors and the three-wire DC system
    • AC distribution calculations
    • Unbalanced three-phase four-wire loads
  6. Unit 6: Introduction to Extra High Voltage Transmission

    6 hours

    EHV AC transmission: introduction, advantages and limitations; HVDC transmission: classification, advantages, limitations and applications.

    Examined in the 70-mark end-semester paper

    • Need for EHV transmission
    • HVDC versus EHVAC transmission
    • Classification of HVDC links

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).