PAHSU Final Year Mechanical syllabus

PAHSU · Final Year B.Tech. Mechanical Engineering · NEP 2020

Industrial Hydraulics and Pneumatics

MECHPEC-04C · Programme Elective IV · Semester VII · 4 credits · End-semester 100 only

One of the Programme Elective IV options.

  1. Unit 1: Introduction to Fluid Power and Hydraulic Actuators

    6 hours

    Types, advantages, limits and uses of fluid power; basic hydraulic components; linear and rotary actuators, cushioning, velocity and force; seals and packings.

    Examined in the 100-mark end-semester paper

    • Fluid power systems
    • Hydraulic cylinders and motors
    • Cylinder sizing: thrust and velocity
    • Piping, hoses, couplings and seals
  2. Unit 2: Pumps, Accumulators, Intensifiers and Valves

    8 hours

    Classification, construction and performance of pumps; accumulators and intensifiers; direct and pilot-operated, sequence, counterbalance, unloading and pressure-reducing valves; direction-control valves, spool actuation and centre positions; compensated and non-compensated flow-control valves and check valves; their symbols.

    Examined in the 100-mark end-semester paper

    • Hydraulic pumps
    • Pump performance and selection
    • Accumulators and intensifiers
    • Pressure control valves
    • Direction control valves
    • Flow control valves
    • Fluid power symbols
  3. Unit 3: Hydraulic Circuits

    6 hours

    Meter-in, meter-out and bleed-off speed control; regenerative, sequencing, counterbalancing and synchronising circuits; circuits with accumulators and intensifiers.

    Examined in the 100-mark end-semester paper

    • Hydraulic circuit design
    • Sequencing, synchronising and fail-safe circuits
    • Hydraulic cylinder design and meter-in and meter-out circuits
  4. Unit 4: Pneumatic Systems and Actuators

    6 hours

    Advantages, limits and uses of pneumatics compared with hydraulics; ISO symbols; pneumatic cylinders and air motors.

    Examined in the 100-mark end-semester paper

    • Pneumatic system components
    • Pneumatic valves and actuators
  5. Unit 5: Pneumatic System Elements and Valves

    8 hours

    Air compressors and their selection; the FRL unit; direction-, flow- and pressure-control valves, quick-exhaust and time-delay valves.

    Examined in the 100-mark end-semester paper

    • Pneumatic systems, valves and FRL units
  6. Unit 6: Pneumatic Circuits

    6 hours

    Simple and time-delay circuits; pneumatic clamping, braking systems and power tools.

    Examined in the 100-mark end-semester paper

    • Pneumatic circuits

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).