Mumbai University · Second Year Mechanical Engineering · NEP 2020
Theory of Machines
2404113 · Semester IV · 3 credits · Internal tests 40 + end-semester 60
End-semester paper (2 hours): Six questions of 20 marks; Q1 is compulsory and you answer three. Each module's share of the paper follows its lecture hours.
Module 1: Basic Kinematics
6 hoursLinks, pairs and chains; constrained motion; mechanisms, machines and structures; degrees of freedom and the Kutzbach and Grübler criteria; inversions of four-bar, slider-crank and double slider-crank chains; single and double Hooke's joints.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Links, pairs and kinematic chains
- Degrees of freedom and Grübler's criterion
- Inversions of the four-bar chain
- Inversions of slider-crank and double slider-crank chains
- Hooke's joint
Module 2: Velocity and Acceleration Analysis
8 hoursGraphical relative velocity and acceleration analysis of mechanisms up to six links (no numericals on the Coriolis component).
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Velocity analysis by relative velocity
- Graphical acceleration analysis
Module 3: Cams and Followers
6 hoursClassification and terminology; uniform velocity, SHM, uniform acceleration and cycloidal motions; displacement, velocity and acceleration diagrams.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Types of cams and followers
- Follower motions: SHM, uniform acceleration and cycloidal
- Displacement, velocity and acceleration diagrams of followers
Module 4: Power Transmission
6 hoursTypes of belts, belt tensions and the condition for maximum power; chain drives and chain length; types of brakes.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Belt drives and belt tensions
- Condition for maximum power transmission
- Chain drives
- Types of brakes
Module 5: Gears
6 hoursLaw of gearing; tooth forms and terminology; path and arc of contact; contact ratio; interference and the minimum number of teeth.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Gear terminology and the law of gearing
- Path and arc of contact and contact ratio
- Interference and minimum number of teeth
Module 6: Governors and Gyroscopes
8 hoursCentrifugal and inertia governors; force analysis of Porter and Hartnell governors; gyroscopic couple; its effect on spinning bodies and on ships in steering, pitching and rolling.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Porter and Hartnell governors
- Gyroscopic couple
- Gyroscopic effect on naval ships
Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.