Mumbai University BE EXTC syllabus

Mumbai University · Final Year Electronics and Telecommunication Engineering · Rev-2019 'C' Scheme

RF Design

ECCDLO8015 · Department Optional Course 5 · Semester VIII · 3 credits · Internal tests 20 (average of two) + end-semester 80

End-semester paper (3 hours): Six questions of 20 marks; Q1 is compulsory and you answer four. Each module's share of the paper follows its lecture hours.

One of the Department Optional Course 5 options.

  1. Module 1: RF Filter Design

    8 hours

    Periodic structures; image-parameter design; insertion-loss design with maximally flat and equal-ripple prototypes; filter transformation and implementation.

    Examined in the 80-mark end-semester paper (about 21% of it, by lecture hours); the class tests cover what has been taught by then

    • Periodic structures
    • Filter design by the image parameter method
    • Insertion loss filter design
    • Filter transformation and implementation
  2. Module 2: Microwave Amplifier Design

    10 hours

    Two-port power gains, signal flow graphs and stability; maximum and specified-gain design; low-noise design; power amplifier classes and class A design.

    Examined in the 80-mark end-semester paper (about 26% of it, by lecture hours); the class tests cover what has been taught by then

    • Two-port power gains and stability
    • Amplifier design for maximum and specified gain
    • Low-noise amplifier design
    • Class A power amplifier design
  3. Module 3: Microwave Oscillators

    6 hours

    One-port oscillator design; phase noise.

    Examined in the 80-mark end-semester paper (about 15% of it, by lecture hours); the class tests cover what has been taught by then

    • One-port microwave oscillators
    • Phase noise in oscillators
  4. Module 4: Microwave Mixers

    5 hours

    Mixer characteristics; single-ended diode, FET, balanced and image-reject mixers.

    Examined in the 80-mark end-semester paper (about 13% of it, by lecture hours); the class tests cover what has been taught by then

    • Mixer characteristics
    • Diode, FET, balanced and image-reject mixers
  5. Module 5: EMI in RF Circuits

    4 hours

    Natural and man-made EMI; interference elements; common-mode, differential-mode and other coupling.

    Examined in the 80-mark end-semester paper (about 10% of it, by lecture hours); the class tests cover what has been taught by then

    • Sources of EMI
    • EMI coupling modes
  6. Module 6: Electromagnetic Compatibility

    6 hours

    Grounding, bonding and shielding; EMI diagnostics; probes, LISN, spectrum analysers and EMI receivers; surge, EFT and susceptibility; MIL-STD, FCC and CISPR.

    Examined in the 80-mark end-semester paper (about 15% of it, by lecture hours); the class tests cover what has been taught by then

    • Grounding, bonding and shielding
    • EMI measurement instruments
    • EMC standards: MIL-STD, FCC and CISPR

Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.