KBCNMU TY Mechanical syllabus

KBCNMU · Third Year B.E. Mechanical Engineering · NEP 2020

Machine Element & System Design

ME-603 · Semester VI · 3 credits · ISE 40 + ESE 60

  1. Unit 1: Introduction to Machine Element Design

    9 hours

    The design procedure, design data, standardisation and preferred sizes, stress concentration, static failure theories, aesthetic and ergonomic considerations, and shafts designed for strength and rigidity to the ASME code.

    Examined in the 60-mark end-semester paper

    • The machine design process
    • Material selection and factor of safety
    • Stress concentration
    • Theories of failure in design
    • Design of shafts for strength
    • Design of shafts for rigidity and the ASME code
  2. Unit 2: Design of Joints and Springs

    9 hours

    Bolts under static, dynamic and eccentric loads; helical compression and tension springs, Wahl's factor, leaf springs, nipping and shot peening.

    Examined in the 60-mark end-semester paper

    • Threaded fasteners and bolts of uniform strength
    • Eccentrically loaded bolted joints
    • Design of helical springs
    • Leaf springs and nipping
  3. Unit 3: Design of Spur and Helical Gears

    9 hours

    Gear terminology, tooth failure and gear materials; spur gears: force analysis, Lewis beam strength, velocity and service factors, wear strength and Buckingham's dynamic load; helical gears: virtual teeth, forces and strength.

    Examined in the 60-mark end-semester paper

    • Gear materials and modes of tooth failure
    • Spur gear force analysis
    • Beam strength: the Lewis equation
    • Wear strength and dynamic load: Buckingham's equation
    • Design of spur gears
    • Design of helical gears
  4. Unit 4: Design of Bearings

    9 hours

    Types of rolling bearings, static and dynamic load capacity, Stribeck's equation, equivalent load and life, catalogue selection, cyclic loads and reliability other than 90%.

    Examined in the 60-mark end-semester paper

    • Types of rolling contact bearings
    • Static and dynamic load capacity
    • Equivalent load and bearing life
    • Selecting bearings from a catalogue
    • Bearing life for cyclic loads and reliability other than 90%
  5. Unit 5: Design for Fluctuating Loads

    9 hours

    Fluctuating and reversed stresses, fatigue, the endurance limit and notch sensitivity, S–N curves, Soderberg and Goodman criteria, and design for finite and infinite life under combined stresses.

    Examined in the 60-mark end-semester paper

    • Fatigue, S–N curve and endurance limit
    • Soderberg, Goodman and Gerber criteria
    • Finite life and cumulative damage

Unit contents are summarised from the official KBCNMU syllabus . AiCanCode.org is not affiliated with Kavayitri Bahinabai Chaudhari North Maharashtra University (KBCNMU).