GUG TY Mechanical syllabus

GUG · Third Year B.Tech. Mechanical Engineering · NEP 2020

Metrology and Quality Control

STPECMEC605B · Program Elective II · Semester VI · 3 credits · IE 10 + mid-semester 10 + ESE 80

One of the Program Elective II options.

  1. Unit 1: Introduction to Metrology

    9 hours

    Types of metrology and the need for inspection; methods of measurement and selection of instruments; errors, units, standards and calibration; statistical concepts in metrology.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Measurement standards, errors and uncertainty
    • Accuracy, precision and gauge R&R
  2. Unit 2: Linear and Form Metrology

    9 hours

    Steel rules, callipers, vernier callipers, height and depth gauges, micrometers and slip gauges; measuring straightness, flatness, squareness, parallelism, roundness and cylindricity.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Linear measuring instruments and gauges
    • Interferometry and flatness testing
    • Geometric dimensioning and tolerancing
  3. Unit 3: Screw Thread and Gear Measurement

    9 hours

    Screw thread terminology and measurement; types of gears, gear terminology and measurement.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Screw thread metrology
    • Gear metrology
  4. Unit 4: Quality Control

    9 hours

    Quality, its functions and objectives; quality of design and of conformance; process control charts and process capability; statistical quality control.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Quality concepts and cost of quality
    • Variation and statistical process control
    • Control charts for variables
    • Control charts for attributes
    • Process capability indices
  5. Unit 5: Acceptance Sampling

    9 hours

    Acceptance sampling, OC curves, sampling plans, and types and objectives of inspection.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Acceptance sampling and OC curves
    • Sampling plans: single, double, multiple and sequential

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.