GUG TY Civil syllabus

GUG · Third Year B.Tech. Civil Engineering · NEP 2020

Design of Steel Structure

STPCCCEC602 · Semester VI · 3 credits · IE 10 + mid-semester 10 + ESE 80

  1. Unit 1: Introduction and Roof Trusses

    9 hours

    Steel as a structural material, grades and properties, rolled, cold-formed and tubular sections; IS 800, 808, 816 and 875; dead, live and wind loads on roof trusses and their design.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Steel structures, sections and IS codes
    • Pre-engineered buildings and cold-formed sections
    • Roof trusses: types, components and loads
    • Design of purlins
  2. Unit 2: Beams

    9 hours

    Simple and built-up beams, laterally restrained and unrestrained, symmetrical and unsymmetrical sections; an introduction to plastic analysis of simply supported beams.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Design bending strength of beams
    • Laterally restrained beams
    • Laterally unrestrained beams
    • Built-up and plated beams
    • Plastic analysis: hinges and collapse mechanisms
  3. Unit 3: Plate Girders and Gantry Girders

    9 hours

    Welded and riveted plate girders and their stiffeners; gantry girders.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Welded plate girder: section design
    • Plate girder stiffeners and connections
    • Gantry girder design
  4. Unit 4: Columns

    9 hours

    Rolled steel columns under axial load and uniaxial or biaxial moment; axially loaded built-up columns; laced and battened columns.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Design of axially loaded columns
    • Columns under axial load and bending
    • Built-up columns: lacing and battening
  5. Unit 5: Connections and Column Bases

    9 hours

    Bolted and welded connections: types, properties and failure, strength of bolts and welds and efficiency of joints; simple and moment-resisting connections; beam-to-beam and beam-to-column framed connections; slab and gusseted column bases.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Bolted and welded connections to IS 800:2007
    • Welded connections and fillet welds
    • Eccentric connections
    • Beam-to-beam connections
    • Slab base
    • Gusseted base

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.