DBATU TY Mechanical syllabus

DBATU · Third Year B.Tech Mechanical Engineering · NEP 2020

Theory of Machines II

Semester VI · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Belt Drives

    Flat belts: slip, creep, crowning, belt length, centrifugal and initial tension, tension ratio and power; V-belts and their tension ratio.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Belt drives and belt tensions
    • Condition for maximum power transmission
  2. Unit 2: Toothed Gears

    Classification and spur gear terminology; conjugate action; involute and cycloidal profiles; path and arc of contact and contact ratio; interference, undercutting and backlash; internal and helical gears.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Gear terminology and the law of gearing
    • Path and arc of contact and contact ratio
    • Interference and minimum number of teeth
    • Helical, bevel and worm gears
  3. Unit 3: Worm and Bevel Gears and Gear Trains

    Worm and bevel gear terminology and the virtual number of teeth; worm gear efficiency; simple, compound and reverted gear trains; simple epicyclic trains and their velocity ratios.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Helical, bevel and worm gears
    • Simple and compound gear trains
    • Epicyclic gear trains and holding torque
  4. Unit 4: Flywheel and Gyroscope

    Turning-moment diagrams; energy stored and fluctuation of energy and speed; flywheels for an engine and a punching press; gyroscopic couple and its effect on aeroplanes, ships and four-wheelers.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Turning moment diagrams and flywheels
    • Gyroscopic couple
    • Gyroscopic effect on naval ships
    • Gyroscopic effect on vehicles
  5. Unit 5: Vibrations

    Single degree of freedom undamped free vibration; natural frequencies of longitudinal and transverse vibration; damped free vibration and types of damping; whirling of shafts; forced vibration; torsional vibration of one- and two-rotor systems.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Free longitudinal and transverse vibrations
    • Damped free vibration
    • Critical speed of shafts
    • Torsional vibration of single and two-rotor systems

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).