DBATU · Third Year B.Tech Mechanical Engineering · NEP 2020
Theory of Machines I
Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60
Unit 1: Introduction
Links, pairs, kinematic chains and inversions of single and double slider-crank chains; kinematic diagrams; equivalent linkages; degrees of freedom; straight-line, pantograph, Geneva and steering mechanisms.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Links, pairs and kinematic chains
- Degrees of freedom and Grübler's criterion
- Inversions of slider-crank and double slider-crank chains
- Equivalent linkages
- Straight-line, Geneva and steering mechanisms
Unit 2: Velocity and Acceleration Analysis
Instantaneous centres, centrodes and Kennedy's theorem; velocity and acceleration diagrams by relative velocity; the Coriolis component; slider-crank analysis by analytical method and Klein's construction.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Instantaneous centres and Kennedy's theorem
- Velocity analysis by relative velocity
- Acceleration analysis and the Coriolis component
- Analytical analysis of the slider-crank mechanism
- Klein's construction
Unit 3: Friction and Lubrication
Dry friction; screw friction; uniform wear and uniform pressure theories; pivots and collars; the friction circle; friction in mechanisms; viscous, boundary, thick-film, hydrostatic and hydrodynamic lubrication.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Friction in screws and threads
- Pivot and collar friction
- Friction circle and friction in turning pairs
- Boundary and film lubrication
Unit 4: Cams and Followers
Types of cams and followers; follower motions; jump and ramp; drawing cam profiles; circular-arc, tangent and cycloidal cams.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Types of cams and followers
- Follower motions: SHM, uniform acceleration and cycloidal
- Drawing cam profiles
- Pressure angle, undercutting and jump
- Circular-arc and tangent cams
Unit 5: Balancing
Balancing rotating masses in one and several planes; reciprocating masses in single and multi-cylinder, inclined, radial and V engines; primary and secondary balancing; direct and reverse cranks; locomotives and partial balancing.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Balancing of rotating masses
- Balancing of reciprocating masses
- Balancing of multi-cylinder, V and radial engines
- Partial balancing of locomotives
Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).