DBATU TY Mechanical syllabus

DBATU · Third Year B.Tech Mechanical Engineering · NEP 2020

Sheet Metal Processing

Elective I · Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

One of the Elective I options.

  1. Unit 1: Introduction

    Importance and advantages of sheet metal parts; design-to-production in the sheet metal industry; materials for sheets, punches and dies and their desirable properties.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Sheet metal materials and their properties
  2. Unit 2: Sheet Metal Blanking and Punching

    Classifying forming operations; mechanics of shearing; blanking, punching and fine blanking; piercing, notching, lancing, trimming and shaving; punch force and its reduction; clearances and punch and die sizes; strippers.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Mechanics of sheet metal shearing
    • Sheet metal operations and presses
    • Punch force, clearance and die sizes
  3. Unit 3: Bending, Centre of Pressure and Strip Layout

    V, edge, air and bottom bending; minimum bend radius and springback; flanging, hemming and curling; bending force and bend allowance; centre of pressure; strip layout; formability and forming-limit diagrams.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Sheet metal bending and springback
    • Die design: strip layout, clearance and press capacity
    • Formability and forming-limit diagrams
  4. Unit 4: Sheet Metal Drawing

    Mechanics of drawing; shallow and deep drawing and ironing; drawing defects; blank size, drawing force and blank-holding force for cups; percentage reduction and the number of draws; reverse redrawing.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Deep drawing and blank development
  5. Unit 5: Dies, Presses and Other Operations

    Compound, progressive and combination dies; mechanical and hydraulic presses; coining, embossing, spinning and stretch forming; explosive, electrohydraulic and electromagnetic forming; case studies.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Compound, progressive and combination dies
    • High energy rate forming processes

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).