DBATU TY Mechanical syllabus

DBATU · Third Year B.Tech Mechanical Engineering · NEP 2020

Metrology and Quality Control

Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Measurement Standards and Comparators

    Line, end and wavelength standards; traceability and calibration; types and sources of error; linear and angular measurement with vernier, micrometer, slip gauges, bevel protractor and sine bar; mechanical, pneumatic and electrical comparators.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Measurement standards, errors and uncertainty
    • Linear measuring instruments and gauges
    • Angular measurement: sine bar and bevel protractor
    • Comparators
  2. Unit 2: Interferometry, Surface Finish and Limits, Fits, Tolerances

    Interference and flatness testing with optical flats; optical and laser interferometers; surface texture and stylus instruments; types of gauges; limits, fits and tolerances (IS 919); Taylor's principle.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Interferometry and flatness testing
    • Surface texture measurement
    • Limits, fits and tolerances
    • Gauge design and Taylor's principle
  3. Unit 3: Metrology of Screw Thread and Gear

    Two- and three-wire methods and the floating carriage micrometer; gear errors, the gear tooth vernier and rolling tester; CMMs, universal measuring machines and lasers in metrology.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Screw thread metrology
    • Gear metrology
    • Coordinate measuring machines
  4. Unit 4: Introduction to Quality and Quality Tools

    Quality statements; cost and value of quality; quality of design, conformance and performance; the seven quality tools, brainstorming and quality circles.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Quality concepts and cost of quality
    • Seven quality tools
    • Kaizen, 5S, poka-yoke and quality circles
  5. Unit 5: Total Quality Management and Statistical Quality Control

    QFD, 5S, kaizen, kanban, JIT, poka-yoke, TPM, FMECA, FTA and zero defects; control charts for variables and attributes; process capability; acceptance sampling; ISO 9000 and standardisation.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Total quality management tools: QFD, JIT and TPM
    • FMEA and FMECA
    • Control charts for variables
    • Control charts for attributes
    • Process capability indices
    • Acceptance sampling and OC curves
    • Quality management systems and awards

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).