DBATU TY Mechanical syllabus

DBATU · Third Year B.Tech Mechanical Engineering · NEP 2020

Mechatronics

Semester VI · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

All notes for this subject
  1. Unit 1: Introduction, Sensors and Transducers

    Mechatronic systems, their elements and examples; pressure, temperature, velocity, acceleration, proximity, position and force sensors; optical encoders, capacitive level and tactile sensors; selecting sensors.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Mechatronic systems and their elements
    • Displacement, position and proximity sensors
    • Velocity, acceleration and force sensors
    • Pressure, temperature and level sensors
    • Optical encoders and sensor selection
  2. Unit 2: Signal Conditioning and Data Representation

    Signals and the need for conditioning; operational amplifiers; opto-isolators and protection; ADCs and DACs; interfacing and relays; seven-segment and LCD displays, printers, data loggers and data acquisition.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Signal conditioning and op-amps
    • ADCs, DACs and interfacing
    • Displays, data loggers and data acquisition
  3. Unit 3: Drives

    AC and DC motors, DC servomotors, stepper motors and linear motors.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • DC motors and servomotors in mechatronics
    • Stepper motors
    • AC and linear motors
  4. Unit 4: Microprocessor, Microcontroller and PLC

    8085 architecture, registers, instructions and interfacing; 8051 microcontroller architecture, pins and instructions; PLC architecture, I/O, selection and ladder and FBD programming.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • 8085 microprocessor architecture and instructions
    • 8051 microcontroller and interfacing
    • Programmable logic controllers
    • Ladder logic and function block programming
  5. Unit 5: Control Systems

    Open and closed loops; block-diagram reduction and transfer functions; spring–dashpot–mass models; on/off, P, I, D, PI, PD and PID control; state-variable models; Bode plots and stability.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Open- and closed-loop systems and block diagrams
    • Modelling mechanical systems
    • On-off and PID controllers
    • Bode plots and stability

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).