DBATU TY E&TC syllabus

DBATU · Third Year B.Tech Electronics & Telecommunication Engineering · NEP 2020

RF Circuit Design

26AF1372PE607B · Elective III · Semester VI · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

One of the Elective III options.

  1. Unit 1: RF Behaviour of Passive Components

    High-frequency resistors, capacitors and inductors; chip components; circuit-board considerations for chip resistors, capacitors and surface-mounted inductors.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • RF behaviour of passive components
    • Chip and surface-mount components
  2. Unit 2: Bandwidth Estimation

    The open-circuit and short-circuit time-constant methods, their accuracy and design examples; delay and rise time of cascaded systems; rise time and bandwidth.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Open-circuit time-constant method
    • Short-circuit time-constant method
    • Rise time and bandwidth of cascaded systems
  3. Unit 3: High-frequency Amplifier Design

    Shunt-peaked and shunt-series-peaked amplifiers; bandwidth enhancement; tuned common-source amplifiers; neutralisation and unilateralisation; RF amplifier characteristics, power relations and stability.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Shunt-peaked amplifiers and bandwidth enhancement
    • Tuned amplifiers, neutralisation and unilateralisation
    • Two-port power gains and stability
  4. Unit 4: Low-noise Amplifier Design

    MOSFET two-port noise parameters; LNA topologies; power-constrained noise optimisation; single-ended and differential LNAs; linearity, large-signal performance and spurious-free dynamic range.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • MOSFET two-port noise parameters
    • Low-noise amplifier design
    • Power-constrained noise optimisation
    • Linearity and spurious-free dynamic range
  5. Unit 5: Oscillators

    Problems with linear oscillators; describing functions and the Colpitts oscillator; quarter-wave and quartz resonators; LC feedback and crystal oscillators; negative-resistance oscillators.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Describing functions and the Colpitts oscillator
    • Resonators, crystal and negative-resistance oscillators
    • Phase noise in oscillators
  6. Unit 6: Mixers

    Mixer fundamentals: conversion gain, noise figure, linearity, isolation and spurs; non-linear systems as mixers; single-balanced, active and passive double-balanced and diode-ring mixers; linearisation.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Mixer characteristics
    • Diode, FET, balanced and image-reject mixers
    • Multiplier-based and double-balanced mixers

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).