DBATU TY Electrical syllabus

DBATU · Third Year B.Tech Electrical Engineering · NEP 2020

Electrical Maintenance and Commissioning of Electrical Equipment

26AF1293VE610 · Semester VI · 2 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

A vocational and skill course: 2 credits and 2 lectures a week in the structure table (its course page says practical, 1 credit). Units 4 and 5 are printed with 2 hours each.

All notes for this subject
  1. Unit 1: Maintenance and Condition Monitoring

    7 hours

    Breakdown, planned and condition-based maintenance; preventive maintenance of transformers, induction motors and alternators; insulation stresses and deterioration, polarisation index and dielectric absorption ratio; condition monitoring and its tools.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Maintenance strategies
    • Preventive maintenance of transformers and motors
    • Insulation deterioration and polarisation index
    • Condition monitoring of electrical equipment
  2. Unit 2: Condition Monitoring of Transformers

    7 hours

    Oil testing to IS/IEC standards and reconditioning; transformer failure modes; monitoring bushings and on-load tap changers; dissolved gas analysis and degree of polymerisation.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Transformer oil testing and reconditioning
    • Condition monitoring of bushings and tap changers
    • Dissolved gas analysis
  3. Unit 3: Condition Monitoring of Induction Motors

    7 hours

    Induction motor parameters; fault diagnosis and monitoring methods; remedies.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Induction motor fault diagnosis
    • Vibration and motor current signature analysis
  4. Unit 4: Testing of Electrical Equipment

    2 hours

    Cable failures, fault location and remedies; type, routine and special tests on transformers; abnormal conditions, troubleshooting and remedies for transformers and induction motors; testing capacitor banks.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Cable fault location
    • Type, routine and special tests on transformers
    • Troubleshooting induction motors and capacitor banks
  5. Unit 5: Special Tests and Earthing

    2 hours

    Ultrasonic and radiographic tests; megger, heat-run and high-voltage withstand tests; substation earthing: equipment and neutral earthing, maintenance-free earthing, plate and pipe electrodes, step and touch voltages, and testing earth resistance.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Ultrasonic and radiographic testing
    • Insulation resistance testing
    • Heat run and high-voltage withstand tests
    • Equipment and neutral earthing
    • Step and touch voltages
    • Earth resistance testing methods

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).