DBATU TY Civil syllabus

DBATU · Third Year B.Tech Civil Engineering · NEP 2020

Open Channel Flow and Hydraulic Machines

26AF1191PC503 · Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Flow in Open Channels

    8 hours

    Types of channels and flow; geometric properties; velocity distribution and measurement by Pitot tube and current meter; sharp, broad and round-crested weirs and notches and their calibration; ogee and siphon spillways; time to empty a reservoir.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Open channel flow and its classification
    • Notches and weirs
    • Velocity measurement in channels
  2. Unit 2: Uniform Flow and Specific Energy

    6 hours

    Chezy's and Manning's equations; the most efficient channel section; computing uniform flow; specific energy and the specific energy curve; critical, subcritical and supercritical flow; specific force.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Uniform flow: Chezy's and Manning's formulae
    • Most economical channel sections
    • Specific energy and critical depth
  3. Unit 3: Non-uniform Flow in Open Channels

    6 hours

    Dynamic equation of gradually varied flow; channel slopes and surface profiles; the step method; rapidly varied flow: the hydraulic jump, its energy loss, sequent depths, location and types; surges.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Gradually varied flow equation
    • Classification of water surface profiles
    • Direct step method
    • Hydraulic jump in rectangular channels
    • Location of hydraulic jump
    • Surges in open channels
  4. Unit 4: Impact of Jets and Hydraulic Turbines

    6 hours

    Impulse–momentum principle; jets on stationary and moving flat and curved vanes and velocity triangles; hydroelectric plants; classification of turbines; Pelton, Francis and Kaplan turbines, performance and selection; cavitation and draft tubes.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Impulse–momentum equation
    • Impact of jet on flat plates
    • Impact of jet on curved vanes
    • Hydroelectric power plant layout
    • Pelton wheel
    • Francis and Kaplan turbines
    • Draft tubes and cavitation
  5. Unit 5: Pumps

    6 hours

    Classification of pumps; reciprocating and centrifugal pumps and their performance; selecting pumps; self-priming; multistage, jet, air-lift and submersible pumps.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Centrifugal pump: construction and working
    • Reciprocating pumps
    • Pump characteristics and multistage pumps
    • Jet, air-lift and submersible pumps

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).