DBATU TY Civil syllabus

DBATU · Third Year B.Tech Civil Engineering · NEP 2020

Design of Steel Structures

26AF1191PC502 · Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Working Stress Method and Design of Connections

    8 hours

    Types of steel structures, grades of steel and loads; working stress and limit state philosophies; permissible stresses and factor of safety; riveted and bolted connections; welded connections: fillet and intermittent welds, failure of welds, welded versus bolted joints.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Steel structures, sections and IS codes
    • Working stress method and permissible stresses
    • Bolted and riveted connections
    • Welded connections and fillet welds
  2. Unit 2: Working Stress Design of Tension and Compression Members

    6 hours

    Tension members: sections, net effective area, capacity and welded or bolted connections; compression members: effective length, slenderness, permissible stress and capacity; columns under axial and eccentric loads; built-up columns, lacing and battening.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Design of tension members and connections
    • Design of axially loaded columns
    • Columns under axial load and bending
    • Built-up columns: lacing and battening
  3. Unit 3: Working Stress Design of Flexural Members, Plastic Analysis

    6 hours

    Sections, lateral stability and lateral torsional buckling; bending and shear design of laterally supported and unsupported beams; plate girder cross-sections; plastic hinges, collapse mechanisms and plastic design.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Laterally restrained beams
    • Laterally unrestrained beams
    • Welded plate girder: section design
    • Plastic analysis: hinges and collapse mechanisms
  4. Unit 4: Limit State Method and Design of Connections

    8 hours

    Limit states of strength and serviceability; probabilistic basis, partial safety factors and load combinations; IS 800:2007 design of welded and bolted connections, axially loaded and eccentric connections.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Limit state design and load combinations
    • Bolted and welded connections to IS 800:2007
    • Eccentric connections
  5. Unit 5: Limit State Design of Axially Loaded and Flexural Members

    8 hours

    Limit state design of tension and compression members and of columns under axial and eccentric loads; bending and shear design of laterally supported beams.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Tension members: yielding, rupture and block shear
    • Buckling and design compressive stress
    • Design bending strength of beams

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).