DBATU SY Mechanical syllabus

DBATU · Second Year B.Tech Mechanical Engineering · NEP 2020

Production Processes I

25AF1612PC401 · Semester IV · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Introduction and Casting Processes

    Manufacturing and process selection; solidification, fluidity, solidification time, shrinkage and porosity; sand, shell, investment, permanent-mould, vacuum, die and centrifugal casting.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Classification of manufacturing processes
    • Solidification of metals and casting fluidity
    • Casting defects and remedies
    • Special casting processes
  2. Unit 2: Metal Forming

    Flat rolling: roll force, torque and power, defects and mills; open, impression and closed-die forging, forging defects and machines; hot, cold, impact and hydrostatic extrusion; drawing practice and defects.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Fundamentals of metal forming
    • Rolling and rolling load
    • Forging and forging load
    • Extrusion, wire and tube drawing
  3. Unit 3: Joining Processes

    Oxy-fuel gas welding; non-consumable and consumable arc welding: SMAW, SAW and GMAW; electrodes; weld quality, weldability and testing; friction and resistance (spot, seam, projection) welding; brazing and soldering.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Gas welding and flames
    • Arc welding: MIG and TIG
    • Welding defects and inspection
    • Solid-state and modern welding processes
    • Resistance welding
    • Soldering, brazing and weld joints
  4. Unit 4: Machining Processes: Turning and Hole Making

    The turning process; lathe components, work holding and operations; types of chips; boring; drilling machines, drills and drilling practice; reaming and tapping.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Lathe and milling operations
    • Chip formation and types of chips
    • Drilling, shaping and broaching machines
    • Boring, reaming and tapping
  5. Unit 5: Machining Processes: Milling, Broaching and Gear Manufacturing

    Peripheral, face and end milling, cutters and milling machines; planing and shaping; broaching; gear form cutting and generating, bevel gears and gear finishing.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Lathe and milling operations
    • Drilling, shaping and broaching machines
    • Gear manufacturing processes

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).