DBATU SY Mechanical syllabus

DBATU · Second Year B.Tech Mechanical Engineering · NEP 2020

Materials Science and Metallurgy

25AF1612PC302 · Semester III · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Structure of Materials

    Unit cells, Bravais lattices and crystal systems; BCC, FCC and HCP structures; Miller and Miller–Bravais indices of planes and directions; point, line, planar and volume defects.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Crystal structures and Miller indices
    • Crystal imperfections and diffusion
  2. Unit 2: Plastic Deformation and Mechanical Properties

    Slip and twinning; Schmid's law and critical resolved shear stress; strain hardening and grain size; tension, compression, hardness, impact and formability tests; non-destructive testing.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Dislocations, slip systems and critical resolved shear stress
    • Cold working and strain hardening
    • Destructive testing of materials
    • Non-destructive testing
  3. Unit 3: Equilibrium Diagrams

    Hume-Rothery rules; Gibbs' phase rule; cooling curves; the lever rule; the iron–iron carbide diagram; classification and specification of steels; transformation products of austenite; TTT and CCT diagrams.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Solid solutions and Hume-Rothery rules
    • Gibbs' phase rule and the lever rule
    • Cooling curves and phase diagrams
    • Iron–carbon equilibrium diagram
    • Designation of steels: IS, AISI and SAE
    • TTT and CCT diagrams
  4. Unit 4: Heat Treatment

    Heating and quenching media; full, isothermal, spheroidise and sub-critical annealing; normalising; hardening and tempering; hardenability and the Jominy test; carburising, nitriding, carbonitriding, flame and induction hardening.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Annealing and normalising
    • Hardening, tempering and hardenability
    • Hardenability and its tests
    • Surface hardening
  5. Unit 5: Metallography

    Specimen preparation, polishing, mounting and etching; the metallurgical microscope; macroscopy: sulphur printing, flow lines, fracture examination and the spark test.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Microscopy and X-ray diffraction
    • Macroscopic examination

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).