DBATU SY Mechanical syllabus

DBATU · Second Year B.Tech Mechanical Engineering · NEP 2020

Machine Drawing and Computer Aided Drafting

25AF1612PC304 · Semester III · 2 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

All notes for this subject
  1. Unit 1: Sectional Views

    Full, half, partial, offset, revolved, removed and auxiliary sections; hatching conventions; sections of machine elements.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Full and half sectional views
    • Offset, revolved, removed and auxiliary sections
    • Hatching conventions for sections
  2. Unit 2: Study of Machine Elements

    Drawing simple machine elements: screwed fasteners, shaft couplings, pipe joints, riveted and welded joints, bearings and gears.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Drawing screwed fasteners
    • Drawing keys, cotters and pin joints
    • Drawing shaft couplings
    • Drawing riveted and welded joints
    • Drawing bearings and pipe joints
  3. Unit 3: Interpenetration of Surfaces

    Curves of intersection of two cylinders, a cone and a cylinder, a prism and a cylinder and a cone and a prism; forged ends.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Intersection of two cylinders
    • Intersection of cones, prisms and cylinders
  4. Unit 4: Drawing of Assembly and Details

    Part and assembly drawings of valves, machine-tool parts, pumps, couplings, pipe fittings and engine parts; production drawings and blueprint reading; limits, fits and tolerances; surface roughness symbols.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Assembly drawings from details
    • Detail drawings from assemblies
    • Production drawings and blueprint reading
    • Limits, fits and tolerances on drawings
    • Surface roughness symbols
  5. Unit 5: Computer Aided Drafting

    Introduction to CADD and its advantages; AutoCAD drawing, dimensioning and viewing commands; 3-D views in AutoCAD.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Introduction to computer-aided drafting
    • AutoCAD drawing and editing commands
    • Dimensioning and viewing in AutoCAD
    • 3D views in AutoCAD

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).