DBATU Final Year Mechanical syllabus

DBATU · Final Year B.Tech Mechanical Engineering · Non-NEP

Processing of Polymers

BTPPE703D · Elective I · Semester VII · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

One of the Elective I options. Carries the Production Engineering code BTPPE703D, as the structure lists it under Elective V.

  1. Unit 1: Compounding and Extrusion

    7 hours

    Plastic additives and compounding; mixing and mixers; extrusion: solids conveying, melting and power in the metering zone; screw design, modelling and simulation; single- and twin-screw extruders.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Plastic additives and compounding
    • Principles of mixing and types of mixers
    • Single-screw extrusion: solids conveying, melting and metering
    • Extrusion screw design and extruder performance
    • Twin-screw extruders
  2. Unit 2: Devolatilisation and Extruded Products

    7 hours

    Devolatilisation in single- and twin-screw extruders; films, pipes, profiles, coatings and foams; sizing, haul-off, cooling and winding; extrusion dies and flow through them; flat, co-extruded and oriented films.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Polymer devolatilisation in extruders
    • Extrusion dies and flow through them
    • Extruded products: films, pipes, profiles and coatings
    • Flat, co-extruded and oriented films
  3. Unit 3: Reactive Extrusion, RTD and Blow Moulding

    7 hours

    Reactive extrusion and residence time distribution; characterising melting and mixing by RTD; extrusion blow moulding, die flow, wall-thickness control, parison swell and sag, and CAE.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Reactive extrusion
    • Residence time distribution in extruders
    • Extrusion blow moulding: parison swell, sag and wall thickness
  4. Unit 4: Thermoforming

    7 hours

    Thermoforming techniques and materials; heat-transfer analysis; the effect of plugs on thickness; heating a thin moving sheet; CAE in thermoforming.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Thermoforming techniques and materials
    • Heat transfer analysis in thermoforming
  5. Unit 5: Injection Moulding and Other Processes

    7 hours

    Rheology in injection moulding; flow in the feed system and cavity, mould filling and process control; reaction injection moulding; calendering, compression, transfer and rotational moulding, casting and decoration.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Injection moulding: rheology, feed system and mould filling
    • Reaction injection moulding
    • Calendering, compression, transfer and rotational moulding

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).