DBATU Final Year Mechanical syllabus

DBATU · Final Year B.Tech Mechanical Engineering · Non-NEP

Mechatronics

BTMC701 · Semester VII · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

All notes for this subject
  1. Unit 1: Introduction, Sensors and Transducers

    7 hours

    Mechatronic systems, their elements and advantages; pressure, temperature, velocity, acceleration, proximity, position and force sensors, optical encoders, capacitive level and tactile sensors, and selecting a sensor.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Mechatronic systems and their elements
    • Displacement, position and proximity sensors
    • Velocity, acceleration and force sensors
    • Pressure, temperature and level sensors
    • Optical encoders and sensor selection
  2. Unit 2: Signal Conditioning and Data Representation

    7 hours

    Electronic signals and the need for signal processing; op-amps; opto-isolators, protection devices, ADCs, DACs, interfacing devices and relays; displays, printers, data loggers and data acquisition cards.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Signal conditioning and op-amps
    • Opto-isolators, protection devices and relays
    • ADCs, DACs and interfacing
    • Displays, data loggers and data acquisition
  3. Unit 3: Drives

    7 hours

    AC, DC, servo, stepper and linear motors; pneumatic components, FRL units, valves and cylinder sequencing by the cascade and shift-register methods; electro-pneumatic circuits; hydraulic cylinder and piston-rod design, poppet valves, tubing and meter-in and meter-out circuits.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • DC motors and servomotors in mechatronics
    • Stepper motors
    • AC and linear motors
    • Pneumatic systems, valves and FRL units
    • Sequencing pneumatic cylinders: cascade and shift register
    • Electro-pneumatic circuits
    • Hydraulic cylinder design and meter-in and meter-out circuits
  4. Unit 4: Microprocessor, Microcontroller and PLC

    7 hours

    The 8085 microprocessor's architecture, registers, instructions and interfacing; the 8051 microcontroller; PLC architecture, inputs and outputs, selection, and ladder logic and FBD programming.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • 8085 microprocessor architecture and instructions
    • 8051 microcontroller and interfacing
    • Programmable logic controllers
    • Ladder logic and function block programming
  5. Unit 5: Control Systems and Stability

    7 hours

    Open- and closed-loop systems; block-diagram reduction and transfer functions; modelling mechanical systems with springs, dashpots and masses; on-off, P, I, D and PID control; state-variable models; Bode plots and stability.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Open- and closed-loop systems and block diagrams
    • Modelling mechanical systems
    • On-off and PID controllers
    • Bode plots and stability

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).