DBATU Final Year E&TC syllabus

DBATU · Final Year B.Tech Electronics & Telecommunication Engineering · Non-NEP

RF Circuit Design

BTETPE702B · Elective I · Semester VII · 4 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

One of the Elective I options.

All notes for this subject
  1. Unit 1: RF Behaviour of Passive Components

    7 hours

    High-frequency resistors, capacitors and inductors; chip components; circuit-board considerations for chip resistors, capacitors and surface-mounted inductors.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • RF behaviour of passive components
    • Chip and surface-mount components
  2. Unit 2: Bandwidth Estimation

    7 hours

    The open-circuit and short-circuit time-constant methods with their accuracy and design examples; delay and rise time of cascaded systems; rise time versus bandwidth.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Open-circuit time-constant method
    • Short-circuit time-constant method
    • Rise time and bandwidth of cascaded systems
  3. Unit 3: High Frequency Amplifier Design

    7 hours

    Shunt-peaked and shunt-series-peaked amplifiers and bandwidth enhancement; the tuned common-source amplifier, neutralisation and unilateralisation; RF amplifier power relations, stability and stabilisation.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Shunt-peaked amplifiers and bandwidth enhancement
    • Tuned amplifiers, neutralisation and unilateralisation
    • Two-port power gains and stability
  4. Unit 4: Low Noise Amplifier Design

    7 hours

    MOSFET two-port noise parameters; LNA topologies; power-constrained noise optimisation; single-ended and differential LNAs; linearity, large-signal performance and spurious-free dynamic range.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • MOSFET two-port noise parameters
    • Low-noise amplifier design
    • Power-constrained noise optimisation
    • Linearity and spurious-free dynamic range
  5. Unit 5: Oscillators and Mixers

    7 hours

    Describing functions and the Colpitts oscillator; quarter-wave and quartz resonators, tuned, crystal and negative-resistance oscillators; mixer conversion gain, noise figure, linearity and spurs; multiplier-based, active and passive double-balanced and diode-ring mixers.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Describing functions and the Colpitts oscillator
    • Resonators, crystal and negative-resistance oscillators
    • Mixer characteristics
    • Multiplier-based and double-balanced mixers

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).