DBATU Final Year E&TC syllabus

DBATU · Final Year B.Tech Electronics & Telecommunication Engineering · Non-NEP

EMI and EMC

BTETOE703F · Elective II · Semester VII · 4 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

One of the Elective II options.

All notes for this subject
  1. Unit 1: Introduction

    7 hours

    History of EMI/EMC; analysing EMI; noise and interference; the benefits of good EMC design; government, commercial and military EMC regulations; examples of EMC problems.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Sources of EMI
    • EMC regulations and the benefits of EMC design
  2. Unit 2: EMC Requirements for Electronic Systems

    7 hours

    Class A and B radiated-emission limits (FCC and CISPR); measuring emissions for compliance; radiated and conducted emission and susceptibility; product requirements and design constraints.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • EMC standards: MIL-STD, FCC and CISPR
    • EMI measurement instruments
  3. Unit 3: Conducted Emission and Susceptibility

    7 hours

    The LISN; common- and differential-mode currents; power-supply filters and their topology; separating conducted emissions for diagnosis; linear and switched-mode supplies and filter placement; conducted susceptibility.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Conducted emission and the LISN
    • Common- and differential-mode currents and power-supply filters
  4. Unit 4: Radiated Emission and Susceptibility

    7 hours

    Differential- and common-mode emission models for wires and PCB lands; current probes; susceptibility models; shielded cables and surface transfer impedance.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • EMI coupling modes
    • Radiated emission models for wires and PCB lands
  5. Unit 5: Shielding and System Design for EMC

    7 hours

    Shielding effectiveness for far- and near-field, electric and magnetic sources; low-frequency magnetic shielding and apertures; grounding, PCB design and system configuration; electrostatic discharge.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Grounding, bonding and shielding
    • Shielding effectiveness: near and far field
    • PCB and system design for EMC

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).