BAMU TY Mechanical syllabus

BAMU · Third Year B.E./B.Tech Mechanical Engineering · NEP 2020

Internal Combustion Engines

MED-355 · Semester VI · 3 credits · CIA 40 + SEE 60

  1. Module 1: Introduction; Fuels, Carburettors and Fuel Injection; Combustion in SI Engines

    15 hours

    Engine components, classification and working, two- and four-stroke and CI and SI engines compared, fuel–air cycles and valve timing; conventional fuels, fuel injection, carburettors, feed and injection pumps, governors and nozzles; stages of SI combustion, detonation, octane rating and combustion chambers.

    Examined in the 60-mark end-semester paper

    • IC engine classification and components
    • Two-stroke and four-stroke engines
    • Valve timing diagrams
    • Fuel–air and actual cycles
    • Simple carburettor and its circuits
    • Fuel injection in SI and CI engines
    • Combustion in SI engines and knock
    • Combustion chambers
  2. Module 2: Combustion in CI Engines; Performance Parameters

    15 hours

    Stages of CI combustion, delay period, diesel knock, cetane rating, CI combustion chambers and turbulence; engine power and efficiencies, performance characteristics and their improvement, heat balance and supercharging.

    Examined in the 60-mark end-semester paper

    • Combustion in CI engines and knock
    • Alternative fuels and fuel ratings
    • Engine performance parameters
    • Heat balance sheet
    • Supercharging and turbocharging
  3. Module 3: Emission from IC Engines; Gas Turbines

    15 hours

    Pollutant formation, BIS and EURO norms, MPFI, CRDI, HCCI and stratified-charge engines, Wankel and Stirling engines; classification and cycles of gas turbines, open and closed cycles, intercooling, reheating and regeneration.

    Examined in the 60-mark end-semester paper

    • Pollutant formation: CO, HC, NOx and particulates
    • Emission measurement, norms and driving cycles
    • Multipoint and direct injection in SI engines
    • CRDI and variable geometry turbochargers
    • Multi-fuel engines and HCCI
    • Wankel and Stirling engines
    • Gas turbine cycles: intercooling, reheating and regeneration

Module contents are summarised from the official BAMU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Marathwada University (BAMU).