BAMU Final Year Mechanical syllabus

BAMU · Final Year B.E. Mechanical Engineering · CBCS (2019)

I.C. Engines and Gas Turbines

MED401 · Semester VII · 4 credits · CT 20 + theory 80

  1. Unit 1: Introduction; Fuels, Carburettors and Fuel Injection

    7 hours

    Engine components, classification and working; two- and four-stroke, SI and CI engines; air-standard, fuel–air and actual cycles; valve timing; fuels and additives, carburettors, injection systems, pumps, governors and nozzles.

    Examined in the 80-mark end-semester paper

    • IC engine classification and components
    • Two-stroke and four-stroke engines
    • Otto, Diesel and dual cycles
    • Fuel–air and actual cycles
    • Valve timing diagrams
    • Simple carburettor and its circuits
    • Fuel injection in SI and CI engines
    • Fuel injection pumps, governors and nozzles
  2. Unit 2: Combustion in SI Engines

    7 hours

    Stages of combustion and the factors affecting them; normal and abnormal combustion; detonation, its causes and effects; octane rating; SI combustion chambers.

    Examined in the 80-mark end-semester paper

    • Combustion in SI engines and knock
    • Alternative fuels and fuel ratings
    • Combustion chambers
  3. Unit 3: Combustion in CI Engines

    6 hours

    Stages of combustion and the delay period; diesel knock and cetane rating; CI combustion chambers and methods of generating turbulence.

    Examined in the 80-mark end-semester paper

    • Combustion in CI engines and knock
    • Combustion chambers
    • Diesel spray behaviour, penetration and air motion
  4. Unit 4: Performance Parameters; Supercharging

    7 hours

    Engine power and efficiencies; performance characteristics and the variables affecting them; improving performance; heat balance; principles, arrangements, advantages and limits of supercharging.

    Examined in the 80-mark end-semester paper

    • Engine performance parameters
    • Heat balance sheet
    • Supercharging and turbocharging
  5. Unit 5: Emissions and Recent Trends

    5 hours

    Emissions, their health effects, formation and control; BIS and Euro norms; microprocessor-based, MPFI, CRDI, variable valve timing and HCCI engines; stratified, Wankel and Stirling engines.

    Examined in the 80-mark end-semester paper

    • Engine emissions and their control
    • Emission measurement, norms and driving cycles
    • Multipoint and direct injection in SI engines
    • CRDI and variable geometry turbochargers
    • Multi-fuel engines and HCCI
    • Wankel and Stirling engines
  6. Unit 6: Gas Turbines

    8 hours

    Classification and applications; ideal and actual cycles; closed- and open-cycle constant-pressure gas turbines compared; improving thermal efficiency with intercooling, reheating and regeneration; gas turbines versus IC engines.

    Examined in the 80-mark end-semester paper

    • Gas turbine cycles: intercooling, reheating and regeneration
    • Open- and closed-cycle gas turbines

Unit contents are summarised from the official BAMU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Marathwada University (BAMU).