BAMU Final Year Electrical syllabus

BAMU · Final Year B.E. Electrical Engineering · CBCS (2019)

Electrical System Planning and Design

EEP/492 · Elective II · Semester VIII · 4 credits · CT 20 + theory 80

One of the Elective II options.

All notes for this subject
  1. Unit 1: Design of Simple Electrical Circuits

    4 hours

    Simple light and fan circuits, systems of connection and accessories; simple alarm circuits with and without relays.

    Examined in the 80-mark end-semester paper

    • Simple light, fan and alarm circuits
    • Procedure of wiring planning
  2. Unit 2: Design of Power and Control Circuit Installation

    8 hours

    Design considerations for installations; fuses and protection; earthing, soil resistivity and electrodes; single- and three-phase residential installations; busbars, busbar chambers and mounting CTs and PTs.

    Examined in the 80-mark end-semester paper

    • Earthing design
    • Fuses and protective devices in installations
    • Single and three-phase residential installations
    • Bus bar chambers and mounting of CTs and PTs
  3. Unit 3: Design of Illumination Schemes

    6 hours

    Illumination terms and laws, light sources and practical schemes; industrial, playground and commercial lighting design.

    Examined in the 80-mark end-semester paper

    • Preliminary interior lighting design
    • Types of lamps for buildings
    • Industrial, playground and commercial lighting design
  4. Unit 4: Substation

    8 hours

    Types of substation, equipment and accessories; pole-mounted outdoor and floor-mounted indoor substations with their single-line diagrams and estimates.

    Examined in the 80-mark end-semester paper

    • Types of substations and their equipment
    • Outdoor substation single-line diagram and estimate
    • Indoor floor-mounted substation design
  5. Unit 5: Electrical Installation for Different Types of Building and Small Industries

    6 hours

    Installations for commercial buildings and small industries; PFC and APFC panels; control panel and cable design; transformer specifications and earthing.

    Examined in the 80-mark end-semester paper

    • Electrical installations for commercial buildings and small industries
    • Power factor improvement and capacitor placement
    • Cable selection and sizing
    • Transformer selection and sizing
  6. Unit 6: Motor Control Circuits

    8 hours

    Starting squirrel cage, multi-speed, wound rotor and synchronous motors; stopping motors; contactor-relay logic, wiring, ferruling and relay and connector boards.

    Examined in the 80-mark end-semester paper

    • Motor starting and control circuits
    • Contactor-relay logic and control panel wiring

Unit contents are summarised from the official BAMU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Marathwada University (BAMU).