SUK TY Mechanical syllabus

SUK · Third Year B.Tech. Mechanical Engineering · NEP 2020

Industrial Fluid Power

ME0262 · Semester VI · 3 credits · ISE 10 + mid-semester 30 + ESE 60

All notes for this subject
  1. Unit 1: Introduction to Fluid Power

    6 hours

    Classification, features and applications of fluid power, ISO/JIC symbols; principles of hydraulic systems, hydraulic fluids and their selection; pneumatics compared with hydraulics.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Fluid power systems
    • Fluid power symbols
    • Hydraulic fluids
  2. Unit 2: Control of Fluid Power Elements

    7 hours

    Pressure relief, reducing, sequence and counterbalance valves; 2/2 to 5/2 direction control valves, centre configurations and actuation, check valves; temperature- and pressure-compensated flow control valves.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Pressure control valves
    • Direction control valves
    • Flow control valves
  3. Unit 3: Elements of Hydraulic System

    7 hours

    Seals, pipes and hoses, contamination control, strainers, filters, heat exchangers and reservoirs; gear, vane, piston and screw pumps and their selection; linear and rotary actuators, hydraulic motors and cylinder mountings; accumulators and intensifiers.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Piping, hoses, couplings and seals
    • Power units and reservoirs
    • Hydraulic pumps
    • Pump performance and selection
    • Hydraulic cylinders and motors
    • Accumulators and intensifiers
  4. Unit 4: Elements of Pneumatic System

    7 hours

    Compressors, capacity control and piping; pneumatic direction, check, flow and pressure control valves, quick exhaust, time delay, shuttle and twin-pressure valves; actuators and air motors; FRL units, mufflers and dryers.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Pneumatic system components
    • Pneumatic valves and actuators
  5. Unit 5: Hydraulic and Pneumatic Circuits

    7 hours

    Meter-in, meter-out, bleed-off, regenerative and fast-approach circuits; travel- and pressure-dependent sequencing; synchronising circuits; pneumatic speed control, impulse, sequence and time-delay circuits.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Hydraulic circuit design
    • Sequencing, synchronising and fail-safe circuits
    • Pneumatic circuits
  6. Unit 6: Recent Trends in Industrial Fluid Power

    6 hours

    Hydraulic and pneumatic servo systems for linear and rotary motion; maintenance, troubleshooting and safety.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Servo and proportional valves
    • Maintenance and fault finding in pneumatic systems

Unit contents are summarised from the official SUK syllabus . AiCanCode.org is not affiliated with Shivaji University, Kolhapur.