SUK TY E&TC syllabus

SUK · Third Year B.Tech. Electronics and Telecommunication Engineering · NEP 2020

Microprocessor and Microcontroller

ETC0261 · Semester VI · 3 credits · ISE 10 + mid-semester 30 + ESE 60

  1. Unit 1: Introduction to 8085 Microprocessor

    6 hours

    Pin-out, CPU architecture and registers, demultiplexing the address/data bus, addressing modes, instruction set and programming.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • 8085 architecture and functional blocks
    • 8085 pin diagram and signals
    • Demultiplexing the address/data bus
    • 8085 addressing modes
    • 8085 assembly language programming
  2. Unit 2: Introduction to MCS-51 (8051)

    6 hours

    The MCS-51 family, pin-out, architecture and registers, memory organisation, I/O ports, reset and oscillator circuits.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • 8051 architecture, pins and special function registers
    • 8051 memory organisation, I/O ports and stack
  3. Unit 3: 8051 Programming in Assembly Language

    6 hours

    Addressing modes, instruction set, assembler directives, data manipulation, branching and simple port programs.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • 8051 addressing modes and instruction set
    • Assembly language programs for the 8051
  4. Unit 4: Hardware Overview

    6 hours

    Timers/counters, interrupts and serial communication (mode 1): configuration, structure and SFRs.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • 8051 timers and counters
    • 8051 serial communication and interrupts
  5. Unit 5: 8051 Programming in Embedded C

    6 hours

    Data types in 8051 C, port programming, logic and bitwise operations, delays with and without timers, counter and serial port programming.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Embedded C basics
    • 8051 programming in C: data types, time delays and I/O
  6. Unit 6: Peripheral Interfacing and Programming

    6 hours

    Interfacing switches, LEDs, LCDs, ADCs, DACs and stepper motors in embedded C.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Interfacing LEDs, seven-segment displays, LCDs and relays with the 8051
    • Interfacing ADC and DAC with the 8051
    • Interfacing stepper motors, keyboards and DACs with the 8051

Unit contents are summarised from the official SUK syllabus . AiCanCode.org is not affiliated with Shivaji University, Kolhapur.