SUK TY E&TC syllabus

SUK · Third Year B.Tech. Electronics and Telecommunication Engineering · NEP 2020

Digital Design using VLSI

ETC0252 · Semester V · 3 credits · ISE 10 + mid-semester 30 + ESE 60

  1. Unit 1: Introduction to Digital Design and Verilog

    6 hours

    K-maps of two to four variables with don't-cares; HDLs and Verilog, abstraction levels (behavioural, dataflow, structural), lexical elements, data types, modelling styles and statements.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • K-map minimisation with don't-care conditions
    • Levels of abstraction in Verilog
    • Verilog data types and number representation
    • Verilog operators
  2. Unit 2: Combinational Logic

    6 hours

    Adders and subtractors, binary–Gray, BCD–excess-3 and BCD–7-segment converters, multiplexers, demultiplexers, encoders, priority encoders, decoders, comparators and the ALU; Verilog for combinational circuits.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Adders, subtractors and the look-ahead carry generator
    • Code converters
    • Multiplexers and multiplexer trees
    • Demultiplexers and decoders
    • Magnitude comparator
    • Combinational circuits in Verilog
  3. Unit 3: Sequential Circuits

    6 hours

    The 1-bit memory cell; SR, JK, D and T latches, clocked latches and flip-flops, preset and clear, excitation tables; Verilog for sequential circuits.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Latches and the SR flip-flop
    • JK, master–slave JK, D and T flip-flops
    • Excitation tables and flip-flop conversion
    • Flip-flops with synchronous and asynchronous reset
  4. Unit 4: Counters and Shift Registers

    6 hours

    Ripple, synchronous, up/down, ring, Johnson and mod-N counters; shift registers; Verilog for counters.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Ripple and mod-n counters
    • Synchronous and up/down counters
    • Ring and twisted-ring counters, sequence generators
    • Registers and shift registers
    • Counters and shift registers in Verilog
  5. Unit 5: Finite State Machines

    6 hours

    Moore and Mealy machines, state diagrams and tables, state assignment and reduction, sequence detectors; Verilog for FSMs.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Moore and Mealy machines
    • State diagrams, state tables and state reduction
    • Sequence detector design
    • Moore and Mealy FSMs in Verilog
  6. Unit 6: VLSI Communication Protocols

    6 hours

    On-chip AMBA buses (AXI, AHB, APB); peripheral protocols I2C, SPI, UART, PCIe and USB (block diagrams).

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • AMBA bus architecture
    • Serial peripheral protocols: I2C, SPI, UART, USB and PCIe

Unit contents are summarised from the official SUK syllabus . AiCanCode.org is not affiliated with Shivaji University, Kolhapur.