SUK · Third Year B.Tech. Civil Engineering · NEP 2020
Theory of Structures
CE0251 · Semester V · 3 credits · ISE 10 + mid-semester 30 + ESE 60
Unit 1: Fundamentals of Structure and Analysis of Redundant Beams
8 hoursTypes of structures by structural form; static and kinematic indeterminacy; propped cantilevers, fixed and continuous beams up to two degrees of indeterminacy by consistent deformation; Castigliano's method; Clapeyron's theorem of three moments.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Static and kinematic indeterminacy
- Propped cantilever by consistent deformation
- Fixed beams
- Continuous beams by consistent deformation
- Strain energy and Castigliano's theorems
- Theorem of three moments
Unit 2: Classical Displacement Methods for Indeterminate Structures
6 hoursSlope-deflection equations applied to continuous beams and simple rigid frames, with and without settlement; moment distribution for continuous beams and sway and non-sway rigid frames.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Slope-deflection equations
- Beams by slope deflection
- Sway frames by slope deflection
- Stiffness, carry-over and distribution factors
- Beams by moment distribution
- Sway frames by moment distribution
Unit 3: Approximate Methods of Frame Analysis
6 hoursApproximate analysis of multi-storey building frames for vertical and lateral loads: the portal and cantilever methods; substitute frames for estimating maximum internal forces.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Portal method
- Cantilever method
- Substitute frame analysis
Unit 4: Force (Flexibility) and Displacement (Stiffness) Methods
8 hoursThe flexibility method: choosing redundants and writing compatibility equations for beams, indeterminate trusses and simple frames; member stiffness matrices for beam and frame elements, global assembly and direct stiffness solution by hand.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Flexibility and stiffness concepts
- Flexibility method for beams and frames
- Redundant trusses by the unit load method
- Stiffness method: structure and member approaches
- Beams by the stiffness method
- Portal frames by the stiffness method
Unit 5: Plastic Analysis of Structures
6 hoursPlastic hinges, plastic moment and shape factor; collapse mechanisms; the static and kinematic theorems applied to beams and frames.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Plastic hinges and shape factor
- Collapse loads by static and kinematic methods
Unit 6: Introduction to the Finite Element Method
6 hoursApplications and general steps of FEM, element types and convergence, coordinate systems, commercial pre-processors, solvers and post-processors; strain-displacement and stress-strain relations in 1D, 2D and 3D; plane stress and plane strain.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Finite element method: discretisation and element types
- Steps in the finite element method
- Displacement functions and convergence
- Strain-displacement relations and compatibility
- Plane stress and plane strain elements
Unit contents are summarised from the official SUK syllabus . AiCanCode.org is not affiliated with Shivaji University, Kolhapur.