SPPU TE Mechanical syllabus

SPPU · Third Year Mechanical Engineering · 2024 Pattern

Industrial Tribology

PEC 361A-MEC · Elective I · Semester VI · 3 credits · CCE 30 + end-semester 70

One of the Elective I options.

All notes for this subject
  1. Unit 1: Introduction to Tribology

    7 hours

    Tribology in design and industry; lubricants: viscosity and its measurement, modes of lubrication, grades, selection, hazards, recycling and disposal; bearing materials and construction, seals and gaskets; laws, causes, measurement and theories of friction; types, factors, measurement and theories of wear.

    Marks: 14 in the end-semester exam · CCE: Unit test (12 marks, Units 1 & 2)

    • Tribology and its importance
    • Lubricants and their properties
    • Viscosity and its measurement
    • Friction: laws and theories
    • Wear: types and mechanisms
  2. Unit 2: Hydrostatic Lubrication

    7 hours

    Hydrostatic step bearing: load capacity and oil flow; squeeze films between circular and rectangular plates approaching a plane.

    Marks: 14 in the end-semester exam · CCE: Unit test (12 marks, Units 1 & 2)

    • Hydrostatic lubrication
    • Hydrostatic step bearing
    • Squeeze film lubrication
  3. Unit 3: Hydrodynamic Lubrication

    8 hours

    Pressure development in an oil film, Reynolds' equation in two dimensions, Petroff's equation, long and short journal bearings, load capacity, the Sommerfeld number; hydrodynamic thrust bearings.

    Marks: 14 in the end-semester exam · CCE: Assignments or case study (12 marks, Units 3 & 4)

    • Mechanism of hydrodynamic lubrication
    • Reynolds' equation
    • Petroff's equation
    • Long and short journal bearings
    • Hydrodynamic thrust bearings
  4. Unit 4: Elasto-hydrodynamic lubrication and Gas Lubrication

    7 hours

    Hertzian contact, EHL in line and point contacts and its regimes, the pressure–viscosity relation, stick–slip; gas lubrication: gas properties, externally pressurised and porous gas bearings, dynamic behaviour, rarefaction and the Knudsen number.

    Marks: 14 in the end-semester exam · CCE: Assignments or case study (12 marks, Units 3 & 4)

    • Hertzian contact theory
    • Elastohydrodynamic lubrication
    • Gas-lubricated bearings
  5. Unit 5: Advances in Tribology

    7 hours

    IoT and AI in tribology, surface topography and its measurement, bio-lubricants and green tribology, nanotribology, tyre–road contact and future trends.

    Marks: 14 in the end-semester exam · CCE: Seminar, open-book test or quiz (6 marks, Unit 5)

    • Surface topography and its measurement
    • Green tribology and bio-lubricants
    • Nanotribology, IoT and AI in tribology

Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.