SPPU TE Electrical syllabus

SPPU · Third Year Electrical Engineering · 2024 Pattern

Power Electronics

PCC-302-ELE · Semester V · 3 credits · CCE 30 + end-semester 70

  1. Unit 1: Power Devices and Protection

    8 hours

    SCR construction, static and dynamic characteristics and ratings; R, RC and UJT triggering; class C and D commutation; TRIAC and its four quadrants; MOSFET and IGBT; SiC and GaN wide-bandgap devices.

    Marks: 14 in the end-semester exam · CCE: Unit test (12 marks, Units 1 & 2)

    • SCR characteristics and ratings
    • SCR triggering circuits
    • Commutation techniques
    • TRIAC
    • Power MOSFET and IGBT
    • Wide-bandgap devices: SiC and GaN
  2. Unit 2: DC–DC Converters

    8 hours

    Choppers and their quadrants; PWM, CLC, TRC and frequency modulation; buck, boost and buck–boost converters with R and RL loads; bidirectional converters and the dual active bridge; uses in battery management, EVs and renewables.

    Marks: 14 in the end-semester exam · CCE: Unit test (12 marks, Units 1 & 2)

    • Chopper principle and control techniques
    • Buck converter
    • Boost converter
    • Buck-boost converter
    • Bidirectional DC-DC converters
  3. Unit 3: Single-phase Controlled Rectifiers

    8 hours

    Single-phase half- and fully-controlled converters with R and RL loads; freewheeling diodes; average and RMS voltage, power factor, THD and TUF; dual converters; DC drives and EV chargers.

    Marks: 14 in the end-semester exam · CCE: Assignments or case study (12 marks, Units 3 & 4)

    • Single-phase half-controlled converter
    • Single-phase fully controlled converter
    • Freewheeling diode
    • Converter performance parameters
    • Dual converter
  4. Unit 4: Three-phase Converters and AC Voltage Controllers

    8 hours

    Three-phase half- and fully-controlled converters with R and RL loads, performance and applications; single-phase AC voltage controllers with R and RL loads.

    Marks: 14 in the end-semester exam · CCE: Assignments or case study (12 marks, Units 3 & 4)

    • Three-phase half-controlled converter
    • Three-phase fully controlled converter
    • Single-phase AC voltage controller
  5. Unit 5: Inverters and Drives

    8 hours

    Single-phase full-bridge and three-phase voltage-source inverters; 120° and 180° conduction; single-pulse and sinusoidal PWM; NPC and cascaded H-bridge multilevel inverters; UPS, induction motor drives and EV traction.

    Marks: 14 in the end-semester exam · CCE: Seminar, open-book test or quiz (6 marks, Unit 5)

    • Single-phase full-bridge inverter
    • Three-phase inverter: 120 and 180 degree modes
    • PWM techniques
    • Multilevel inverters

Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.