SPPU SE IT syllabus

SPPU · Second Year Information Technology · 2024 Pattern (Revised)

Digital Electronics and Logic Design

MDM-221-ITT · Semester III · 2 credits · CCE 40 + end-semester 60

All notes for this subject
  1. Unit 1: Introduction to Digital Electronics

    6 hours

    Digital IC characteristics; TTL and CMOS NAND gates and their comparison; sign-magnitude, 1's and 2's complement; binary arithmetic and 2's-complement subtraction; IEEE 754 floating point; BCD, octal, hexadecimal, Excess-3 and Gray codes and conversions.

    Marks: 12 in the end-semester exam · CCE: Unit test (15 marks, Units 1 & 2)

    • Digital IC characteristics
    • TTL and CMOS logic families
    • Signed number representation
    • Binary arithmetic and 2's complement subtraction
    • IEEE 754 floating-point representation
    • Number systems and codes
  2. Unit 2: Combinational Logic Design

    6 hours

    Truth tables, SOP and POS, K-maps up to four variables with don't-cares; code converters, half and full adders and subtractors, n-bit adders; multiplexers (74151, 74153), decoders (74138) and the 7483 adder; BCD adder and implementing functions with MSI chips.

    Marks: 12 in the end-semester exam · CCE: Unit test (15 marks, Units 1 & 2)

    • SOP and POS forms
    • K-map minimisation
    • Adders, subtractors and code converters
    • Multiplexers and decoders
    • BCD adder using IC 7483
    • Implementing functions with multiplexers and decoders
  3. Unit 3: Flip-flops and their Applications

    6 hours

    Combinational versus sequential circuits and latches; SR, JK, D and T flip-flops, excitation tables, preset and clear, master–slave, conversions and flip-flop ICs; switch debouncing; asynchronous, synchronous and mod-n counters with the 7490.

    Marks: 12 in the end-semester exam · CCE: Assignments or case study (15 marks, Units 3 & 4)

    • Latches and sequential circuits
    • SR, JK, D and T flip-flops
    • Master–slave flip-flop and flip-flop conversion
    • Asynchronous and synchronous counters
    • Mod-n counters with IC 7490
  4. Unit 4: Sequential Logic Design

    6 hours

    Buffer and shift registers (SISO, SIPO, PISO, PIPO), ring and twisted-ring counters; state diagrams, tables, reduction and assignment; Mealy and Moore machines; sequence generators and detectors.

    Marks: 12 in the end-semester exam · CCE: Assignments or case study (15 marks, Units 3 & 4)

    • Shift registers
    • Ring and twisted-ring counters
    • State diagram, state table and state reduction
    • Mealy and Moore machines
    • Sequence generators and detectors
  5. Unit 5: Introduction to Computer Architecture

    6 hours

    Computer organisation versus architecture; CPU, memory, I/O and system buses; Von Neumann and Harvard architectures; the instruction cycle; the IAS machine and its registers; hardwired and microprogrammed control units.

    Marks: 12 in the end-semester exam · CCE: Seminar, open-book test or quiz (10 marks, Unit 5)

    • Computer organisation and architecture
    • CPU, memory, I/O and system bus
    • Von Neumann and Harvard architectures
    • Instruction cycle and the IAS computer
    • Hardwired and microprogrammed control units

Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.