SPPU SE Electrical syllabus

SPPU · Second Year Electrical Engineering · 2024 Pattern (Revised)

Analog and Digital Electronics

PCC-202-ELE · Semester III · 3 credits · CCE 40 + end-semester 60

  1. Unit 1: Combinational Circuit Design

    8 hours

    Boolean algebra; Karnaugh maps for two, three and four variables; SOP and POS reduction; designing combinational circuits from Boolean expressions and K-maps; encoders, decoders, half and full adders.

    Marks: 12 in the end-semester exam · CCE: Unit test (15 marks, Units 1 & 2)

    • Boolean algebra
    • Karnaugh maps
    • SOP and POS reduction
    • Encoders and decoders
    • Half and full adders
  2. Unit 2: Sequential Circuit Design

    8 hours

    Sequential circuits; synchronous counters designed with K-maps and asynchronous counters; up–down and mod-N counters; shift registers; ring and twisted-ring counters.

    Marks: 12 in the end-semester exam · CCE: Unit test (15 marks, Units 1 & 2)

    • Introduction to sequential circuits
    • Asynchronous counters
    • Synchronous counter design
    • Up-down and mod-N counters
    • Shift registers
    • Ring and twisted-ring counters
  3. Unit 3: Op-amp Applications

    8 hours

    Open- and closed-loop op-amp configurations; zero-crossing detector, comparator and Schmitt trigger; V–I and I–V converters; instrumentation amplifier; peak detector; sine, square, sawtooth and triangular generators.

    Marks: 12 in the end-semester exam · CCE: Assignments or case study (15 marks, Units 3 & 4)

    • Open-loop and closed-loop op-amp configurations
    • Comparators and zero-crossing detectors
    • Schmitt trigger
    • V-I and I-V converters
    • Instrumentation amplifier
    • Op-amp waveform generators
  4. Unit 4: Active Filters, the 555 Timer and Regulators

    8 hours

    Active filter configurations and frequency response; first-order op-amp low-pass and high-pass filters; IC 555 construction and astable and monostable modes; sequence generators; 78xx, 79xx and LM317 regulators.

    Marks: 12 in the end-semester exam · CCE: Assignments or case study (15 marks, Units 3 & 4)

    • First-order active low-pass and high-pass filters
    • IC 555 timer
    • Astable and monostable multivibrators
    • Voltage regulators: 78xx, 79xx and LM317
  5. Unit 5: Diode Rectifiers

    8 hours

    Single-phase half-wave rectifier with R and RL loads; centre-tap and bridge full-wave rectifiers with R and RL loads and their performance parameters; three-phase full-wave bridge rectifier with R load.

    Marks: 12 in the end-semester exam · CCE: Seminar, open-book test or quiz (10 marks, Unit 5)

    • Single-phase half-wave rectifier
    • Full-wave centre-tap and bridge rectifiers
    • Rectifier performance parameters
    • Three-phase bridge rectifier

Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.