SPPU BE E&TC syllabus

SPPU · Final Year Electronics & Telecommunication Engineering · 2019 Course

Electronic Product Design

404185B · Elective IV · Semester VII · 3 credits · In-semester 30 + end-semester 70

One of the Elective IV options.

All notes for this subject
  1. Unit 1: Introduction to Electronic Product Design

    6 hours

    System engineering perspectives; documentation; concept development and requirements; design development, rapid prototyping and field testing; validation, verification and integration; life-cycle costs; architecture and design heuristics.

    Marks: 15 in the in-semester exam

    • System engineering and product life cycle
    • Requirements and concept development
    • Prototyping, validation and verification
  2. Unit 2: Circuit Design and Testing

    6 hours

    Turning requirements into design; reliability and fault tolerance; high-speed and low-power design; noise and error budgets; standard buses; reset and power-fail detection; I/O; breadboards and evaluation boards.

    Marks: 15 in the in-semester exam

    • Reliability and fault tolerance
    • High-speed and low-power design
    • Noise and error budgets
    • Reset and power-fail circuits
  3. Unit 3: Software Design and Testing

    6 hours

    Software types and life cycle; metrics and limitations; risk abatement; bugs and testing; good programming practice; user interfaces; embedded real-time software.

    Marks: 17–18 in the end-semester exam

    • Software life cycle for products
    • Software testing and bugs
    • Embedded real-time software
  4. Unit 4: PCB Design

    6 hours

    Board types, component placement and routing; grounds, returns and shields; connectors and cables; design for manufacture and test; power conversion and distribution; EMI; thermal design: heat sinks, heat pipes, fans and liquid cooling.

    Marks: 17–18 in the end-semester exam

    • Component placement and routing
    • Grounding and shielding
    • Design for manufacture and test
    • Electromagnetic interference
    • Thermal management and heat sinks
  5. Unit 5: Product Debugging and Testing

    6 hours

    Debugging and troubleshooting steps; characterising passive, active and electromechanical components; testing components; simulation and prototyping; integration, validation, procurement, manufacture and repair.

    Marks: 17–18 in the end-semester exam

    • Debugging and troubleshooting techniques
    • Component inspection and testing
    • Integration, validation and verification
  6. Unit 6: Documentation

    6 hours

    Need and types of documentation; records, accountability and liability; audience; preparing, presenting and preserving documents; visual techniques; bills of material.

    Marks: 17–18 in the end-semester exam

    • Types of product documentation
    • Bill of materials

Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.