SPPU BE Electrical syllabus

SPPU · Final Year Electrical Engineering · 2019 Course

Power Quality Management

403143B · Elective I · Semester VII · 4 credits · In-semester 30 + end-semester 70

One of the Elective I options.

  1. Unit 1: Basics of Power Quality

    7 hours

    IEEE 1159 terms: transients, short- and long-duration variations, interruptions, fluctuations, imbalance and flicker; symptoms of poor quality; grounding practices and their effect on power quality.

    Marks: 15 in the in-semester exam

    • Power quality terms as per IEEE 1159
    • Grounding and power quality
  2. Unit 2: RMS Variations, Flicker and Transients

    7 hours

    Voltage regulation and its devices; reactive power management; causes and effects of flicker; ferroresonance; flicker meters; impulsive and switching transients; surge impedance; transient control.

    Marks: 15 in the in-semester exam

    • Voltage regulation devices
    • Voltage flicker
    • Ferroresonance
    • Transient overvoltages and their control
  3. Unit 3: Voltage Sag, Swell and Interruption

    7 hours

    Causes, cost and characteristics of sags; effect of fault type and location; phase-angle jumps; sag types; equipment sensitivity and the CBEMA, ITIC and SEMI F47 curves; measuring sags; sag indices; mitigation by UPS, DVR, SMES and CVT.

    Marks: 17–18 in the end-semester exam

    • Voltage sags and interruptions
    • Voltage sag characteristics and types
    • CBEMA and ITIC curves
    • Voltage sag mitigation
  4. Unit 4: Harmonics I

    7 hours

    Harmonics, inter- and sub-harmonics; causes and effects; Fourier analysis; harmonic indices; power under distortion; triplen harmonics; harmonics from lighting, SMPS, transformers, machines, drives and arc furnaces.

    Marks: 17–18 in the end-semester exam

    • Harmonic indices and THD
    • Power under non-sinusoidal conditions
    • Triplen harmonics
    • Sources of harmonics
  5. Unit 5: Harmonics II

    7 hours

    Series and parallel resonance; controlling harmonics; K-rated transformers; harmonic studies and tools; passive, tuned and active filters; IEEE 519-2014 and IEEE 1531.

    Marks: 17–18 in the end-semester exam

    • Harmonic resonance
    • K-rated transformers
    • Passive and active harmonic filters
    • IEEE 519 harmonic limits
  6. Unit 6: Power Quality Monitoring

    7 hours

    Monitoring objectives and site surveys; PQ analysers to EN 50160; choosing monitors, locations and transducers; harmonic, transient, event and flicker monitoring; PQ indices and standards.

    Marks: 17–18 in the end-semester exam

    • Power quality monitoring
    • Power quality analysers and EN 50160
    • Power quality indices

Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.