SPPU BE Civil syllabus

SPPU · Final Year Civil Engineering · 2019 Pattern

Airport and Bridge Engineering

401004D · Elective IV · Semester VII · 3 credits · In-semester 30 + end-semester 70

One of the Elective IV options.

  1. Unit 1: Airports and their Classification

    6 hours

    Air transport; airport layout and runway configurations; obstructions and zoning; terminals, aprons and hangars; navigation aids, ILS and air traffic control; ICAO and FAA classification of airports.

    Marks: 15 in the in-semester exam

    • Airport layout and components
    • Airport zoning and obstructions
    • Navigation aids and air traffic control
    • ICAO and FAA airport classification
  2. Unit 2: Aircraft Characteristics and Geometric Design

    6 hours

    Aircraft characteristics affecting airport design; airport planning and site selection; runway and taxiway widths, profile and length with corrections; runway orientation; air travel demand; airport master plans.

    Marks: 15 in the in-semester exam

    • Aircraft characteristics
    • Airport site selection
    • Runway length and its corrections
    • Runway orientation and wind rose
  3. Unit 3: Airport Visualisation, Capacity and Pavements

    6 hours

    BIM, AR and VR in airport planning; runway capacity and the factors affecting it; airfield versus highway pavements; design of rigid and flexible airport pavements; airport drainage.

    Marks: 17–18 in the end-semester exam

    • BIM and virtual reality for airports
    • Runway capacity
    • Airport pavement design
    • Airport drainage
  4. Unit 4: Marking, Lighting and Heliports

    6 hours

    Runway marking and lighting; designation, centre-line, threshold and touchdown markings; helicopter characteristics; heliport planning, marking and lighting; VTOL and STOL.

    Marks: 17–18 in the end-semester exam

    • Airport marking and lighting
    • Heliport planning
    • VTOL and STOL
  5. Unit 5: Introduction to Bridges

    6 hours

    Classification; site selection and surveys; discharge, linear waterway, economic span, afflux and scour; effective width; IRC loads and load distribution; abutments, piers and wing walls.

    Marks: 17–18 in the end-semester exam

    • Bridge site selection and hydraulic data
    • Economic span and scour depth
    • IRC loading standards
    • Bridge substructure
  6. Unit 6: Types of Bridges

    6 hours

    Culverts and design of pipe and box culverts; temporary and movable bridges; fixed-span bridges: arch, cantilever, suspension, cable-stayed and more; bridge bearings.

    Marks: 17–18 in the end-semester exam

    • Design of culverts
    • Movable and temporary bridges
    • Fixed span bridge types
    • Bridge bearings

Unit contents are summarised from the official SPPU syllabus . AiCanCode.org is not affiliated with Savitribai Phule Pune University.