SGBAU SY IT syllabus

SGBAU · Second Year B.E. Information Technology · NEP 2020

Analog & Digital Electronics

3IT202PC · Semester III · 3 credits · IE 40 + ESE 60

All notes for this subject
  1. Unit 1: Introduction to Analog Circuits

    7 hours

    The transistor as an amplifier and the need for biasing; potential-divider bias; the transistor as a switch; construction and working of the JFET and MOSFET.

    Examined in the 60-mark end-semester paper

    • Transistor as a switch and an amplifier
    • DC load line, Q-point and BJT biasing
    • JFET characteristics
    • MOSFET characteristics
  2. Unit 2: Operational Amplifier

    7 hours

    Op-amp block diagram and ideal parameters, the virtual short; inverting and non-inverting amplifiers, voltage follower, summing amplifier and subtractor.

    Examined in the 60-mark end-semester paper

    • Op-amp block diagram and ideal characteristics
    • Op-amp circuits: inverting, non-inverting and summing
  3. Unit 3: Wave Generators

    7 hours

    Transistor RC phase-shift and crystal oscillators; the 555 timer, its block diagram and working, as astable and monostable multivibrator.

    Examined in the 60-mark end-semester paper

    • RC phase-shift oscillator
    • Crystal oscillator
    • IC 555 timer
    • Astable and monostable multivibrators
  4. Unit 4: Introduction to Digital Circuits

    7 hours

    Logic gates, number systems and conversions; realising and minimising expressions with K-maps (up to four variables); half and full adders and subtractors.

    Examined in the 60-mark end-semester paper

    • Logic gates
    • Number systems and codes
    • SOP and POS forms
    • K-map minimisation
    • Adders, subtractors and code converters
  5. Unit 5: Logic Circuits

    7 hours

    Combinational versus sequential circuits; BCD, Excess-3 and Gray code converters; multiplexers, demultiplexers and decoders; SR, JK, D and T flip-flops.

    Examined in the 60-mark end-semester paper

    • Adders, subtractors and code converters
    • Multiplexers and decoders
    • Latches and sequential circuits
    • SR, JK, D and T flip-flops
  6. Unit 6: Sequential Circuits

    7 hours

    Asynchronous versus synchronous sequential circuits; mod of a counter, asynchronous up, down and ring counters; shift registers: SISO, SIPO, PISO and PIPO.

    Examined in the 60-mark end-semester paper

    • Asynchronous and synchronous counters
    • Mod-n counters with IC 7490
    • Ring and twisted-ring counters
    • Shift registers

Unit contents are summarised from the official SGBAU syllabus . AiCanCode.org is not affiliated with Sant Gadge Baba Amravati University (SGBAU).